7.Attach the Backrest (22) to the Upright (3) and Upright Base (1) with four M6 x 16mm Screws (130).
8.Connect the Sensor Wire Harness (187), the Wire Harness (159), and the Upper Wire Harness
(188) to the Console (71). Push the excess wire into the Upright (3).
The connector should slide easily into the sock- et and snap into place. If a connector does not slide easily and snap into place, turn it over and then insert it. IF THE CONNECTOR IS NOT
INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Attach the Console (71) to the Upright (3) with four M4 x 16mm Screws (85). Make sure the wires do not get pinched.
9.Attach the two Swivel Arms (58) to the Top Arm (11) with two M4 x 5mm Screws (131).
10.Attach the Top Arm (11) to the Upright (3) with two M10 x 75mm Patch Screws (99).
Route the Short Cables (163) through the bracket on the back of the Upright (3).
7 |
|
| 130 |
|
|
|
|
| |
| 22 |
|
|
|
|
|
|
| 3 |
|
|
| 130 |
|
|
|
| 1 |
|
8 |
| 85 |
|
|
|
|
|
| |
|
|
| 188 | 3 |
| 85 | 187 |
| 85 |
|
|
|
| |
| 71 |
|
|
|
|
|
| 159 | 85 |
|
|
|
| |
9 | 58 |
|
| |
|
|
| ||
| 131 | 11 | 58 | |
|
|
|
| 131 |
10 |
|
|
|
|
|
|
| 11 |
|
|
|
|
| 99 |
| 163 |
|
| |
|
|
| 3 |
|
|
|
|
| 163 |
|
|
|
| Bracket |
8