ProForm PFEL59107.0 Maintenance and Troubleshooting, Battery Replacement, HOW to Adjust the Belt

Page 19

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.

BATTERY REPLACEMENT

If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 9 on page 9 for replacement instructions.

HANDGRIP PULSE SENSOR TROUBLESHOOTING

•Avoid moving your hands while using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings.

•Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.

•For the most accurate heart rate reading, hold the metal contacts for about 30 seconds.

•For optimal performance of the handgrip pulse sen- sor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth—never use alco- hol, abrasives, or chemicals to clean the con- tacts.

HOW TO ADJUST THE BELT

If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the belt may need to be adjusted. To adjust the belt, first see assembly step 12 on page 10 and remove the left pedal arm and the left link arm.

Then, carefully

 

pry off the left

 

Disc Cover (13)

 

using a flat

 

screwdriver.

 

Next, remove the

 

four screws (not

 

shown) from the

 

center of the left

13

Disc (12). Gently

12

rotate the Disc

 

Cover and the

 

Disc away from the elliptical exerciser.

Loosen, but do

 

not remove, the

 

three indicated

 

screws (A). Insert

74

the shaft of a

 

screwdriver

47

downward

48

between the

A

Idler (47) and the

 

Idler Pulley (48).

 

Pull the top of the

 

screwdriver

 

toward the front

 

of the elliptical exerciser until the Belt (74) is tight. Then, tighten the three screws.

Reattach the left disc with the four screws and then reattach the left disc cover. Next, see assembly step 12 on page 10 and reattach the left pedal arm and the left link arm.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Model No. PFEL59107.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Right Side Before YOU BeginFront RearAssembly Page Avoid pinching Wire Harnesses 64 During this step Avoid pinching the Wire Harnesses 64, 65 during this stepAttach the Right Upper Body Arm 23 in the same way Repeat this step for the Right Upper Body LegSame way Avoid pinching Wire harnesses during this stepAttach the Right Rear Upper Body Cover Right Front Upper Body CoverRepeat this step for the right Pedal HOW to Fold and Unfold the Elliptical Exerciser HOW to USE the Elliptical ExerciserHOW to Move the Elliptical Exerciser HOW to Exercise on the Elliptical Exerciser Features of the Console HOW to USE the Manual Mode Begin pedaling to start the program HOW to USE a Cross Training ProgramTurn on the fan if desired Select one of the six cross training programsToll-free telephone number on the front cover Als will automatically adjust to the resistancePerform the first strength exercise when Prompted Chase dumbbells or an exercise ball, callFollow your progress with the display HOW to USE a Heart Rate ProgramSelect one of the two heart rate programs Follow your progress with the display HOW to Adjust the Belt Maintenance and TroubleshootingBattery Replacement Handgrip Pulse Sensor TroubleshootingExercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Page Page Key No. Qty Description Part LIST-Model No. PFEL59107.0Qty Description Drawing A-Model No Drawing Limited Warranty HOW to Order Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT
Top Page Image Contents