ProForm PFEX59030 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench and Phillips

screwdriver .

Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on page 25. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 Nylon	M6 Washer		M8 Washer	M4 x 12mm	M4 x 16mm	M4 x 20mm
Locknut (49)–4	(66)–4		(64)–2	Screw (41)–4	Screw (57)–10	Screw (101)–1
M6 x 16mm Tapered		M6 x 16mm Button		M6 x 22mm Button		M6 x 25mm Button
Button Screw (102)–8			Screw (8)–4	Screw (93)–3		Screw (99)–1
M8 x 25mm Button			M8 x 38mm Button		M8 x 52mm Button
Screw (40)–4			Bolt (96)–4		Screw (54)–2

1.Orient the Front Stabilizer (15) as shown. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M8 x 52mm Button Screws (54) and two M8 Washers (64).

1

1

15

64

54

5