Brother BAS-761 instruction manual Sewing with the folder in step mode

9. Sewing

9-4. Sewing with the folder in step mode

¡In step mode, the folder operates in a step-by-step manner, so that checking can be carried out during folding.

¡If he LABEL indicator e is switched off, automatic mode is followed during step mode operation. If the LABEL indicator e is illuminated, label attachment mode is followed.

NOTE:

Selecting the mode to be followed is carried out by using the LABEL button e.

Press FOLDER RESET SW

to start searching for home position.

q

e

w

1.Turn on the air pressure and then turn on the power switch.

The screen shown at left will be displayed on the panel.

2.Press the FOLDER RESET button !9. The machine head will move to the home position and then stop in the standby condition.

3.Set the folder to step mode.

NOTE:

Refer to page 18 for details on how to set the folder mode.

4.Press the STACKER button r so that the STACKER indicator is illuminated.

@3

5.Place the workpiece q under the gauge assembly q. (*1)

6.Depress the foot switch @3. The vacuum system will start operating to hold the workpiece q in place.

7.Place the pocket material e on top of the gauge as- sembly w.

8.The folder operates one step at a time each time the STEP button t is pressed.

9.If you continue to press the STEP button t after folding has been completed, the work clamp assembly will move to the folder side and operation will continue from transporting to sewing.

NOTE:

At any point up until the folder is released, the folder can be moved in reverse by depressing and holding the foot switch @3while pressing the STEP button t.

*1 If DIP switch D-1 has been set to ON, the gauge assembly w will retract. The gauge assembly w moves forward at the same time the vacuum system starts operating when the foot switch @3is depressed.

BAS-761 28