English
Receiving Radio Broadcasts
You can browse through all the stations or use the preset function to go immediately to a particular station.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and other countries use 10 kHz spacing. When shipped, the spacing is set to 9 kHz.
On the front panel ONLY:
To select the 10 kHz interval:
Be sure the receiver is tuned off, but is plugged into an AC outlet.
Hold down MULTI CURSOR % and press STANDBY/ON 
. Now the 10 kHz interval is selected.
STANDBY
MULTI CURSOR
and 
/I
STANDBY/ON
To change back to the 9 kHz interval:
Be sure the receiver is tuned off, but plugged into an AC outlet. Hold
down MULTI CURSOR Þ and press STANDBY/ON 
. Now the 9 kHz interval is selected.
MULTI CURSOR |
| STANDBY |
and
/I
STANDBY/ON
Using Preset Tuning
Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 30 FM stations and 15 AM stations.
To store the preset stations
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Tune in the station you want to preset (see “Tuning in Stations Manually”).
If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM Reception Mode”.
2. Press MEMORY. | MEMORY |
CH- _ _
Tuning in Stations Manually
On the front panel ONLY:
1. Press FM or AM.
The last station of the selected band is tuned in.
•MULTI CURSOR % / Þ / @/ #buttons can be now used for operating the tuner.
2.Press MULTI CURSOR %/ Þ repeatedly until
FM
AM
MULTI CURSOR
3. Press MULTI CURSOR @/ #to | MULTI CURSOR |
select a channel number while the |
|
channel number position is |
|
flashing. |
|
Note:
You can use the 10 keys on the remote control to select the preset number. When using the 10 keys, be sure that they are activated for the tuner, not for the CD and others. (See page 22.)
4. Press MEMORY again while the | MEMORY |
selected channel number is |
|
flashing on the display. |
|
The selected channel number stops flashing.
The station is assigned to the selected channel number.
3. Press MULTI CURSOR @/ #
MULTI CURSOR
until you find the frequency you want.
• Pressing @decreases the frequency.
• Pressing #increases the frequency.
Notes:
•When you hold MULTI CURSOR @ / # in step 3, the frequency keeps changing until a station is tuned in.
•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.
When an FM stereo program is received, the STEREO indicator also lights up.
5.Repeat steps 1 to 4 until you store all the stations you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored one.
13