JVC RX-5001VGD manual Press Test to check the speaker, Output balance, Press Rearl / + to adjust

From the remote control:

SOUND

1. Press SOUND CONTROL. CONTROL

3. Press TEST to check the speaker	TEST
output balance.	2 5

English

The 10 keys are activated for sound adjustments.

2.Press SURROUND repeatedly until the DAP mode — DANCE CLUB, LIVE CLUB, HALL, or PAVILION — appears on the display.

SURROUND

3

“TEST” starts flashing on the display, and a
test tone comes out of the speakers in the
following order:
Left front speaker	Center speaker
Rear speaker	Right front speaker

The DAP indicator also lights up on the display.

3. Press REAR•L – / + to adjust the	– REAR•L +
rear speaker output level.	8 5	9

Note:

You can adjust the speaker output levels without outputting the

test tone.

•Pressing REAR•L – decreases the output level up to –10 dB.

•Pressing REAR•L + increases the output level up to +10 dB.

Note:

You cannot adjust the left and right rear speaker output levels separately.

4. Press EFFECT to select an effect	EFFECT
level you want.	45

4.Press CENTER – / + repeatedly to adjust the center speaker output level (from –10 to +10).

5.Press REAR•L – / + to adjust the rear speaker output level (from –10 to +10).

Notes:

– CENTER +

5	6	5
– REAR•L +

8 5 9

• Each time you press the button, the effect
level changes as follows:
EFFECT 1 EFFECT 2 EFFECT 3
EFFECT 5	EFFECT 4

As the number increases, the selected DAP mode becomes stronger.

Adjusting the Surround Modes — Dolby

Surround and JVC Theater Surround

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 11).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•You can only adjust the effect level when selecting JVC Theater Surround.

•You can only adjust the rear and/or center speaker output levels when you have connected rear speakers and/or a center speaker and have set “REAR SPK” and/or “CNTR SPK” correctly. See

page 11.

•You cannot adjust the left and right rear speaker output levels separately.

•You cannot use the REAR•R – / + buttons to adjust the rear speaker output level.

6. Press TEST again to stop the test	TEST
tone.	2 5

7.ONLY FOR JVC Theater Surround:

Press EFFECT to select an effect	EFFECT
	45
level you want.

•Each time you press the button, the effect level changes as follows:

EFFECT 1 EFFECT 2 EFFECT 3

EFFECT 5 EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

From the remote control:

1. Press SOUND CONTROL.

The 10 keys are activated for sound adjustments.

2.Press SURROUND repeatedly until the mode — “PROLOGIC,” “3 STEREO,” or “THEATER” — appears on the display.

SOUND

CONTROL

SURROUND

3

•For “PROLOGIC” and “3 STEREO,” the PRO LOGIC indicator lights up on the display.

•For “THEATER,” the PRO LOGIC and DAP indicators light up on the display.

18