JVC RX-5001VGD manual Connecting the Speakers, AM Antenna ConnectionsBasic connecting procedure

Page 7

AM Antenna ConnectionsBasic connecting procedure

ANTENNA	Snap the tabs on the loop into the	1	2	3
	Snap the tabs on the loop into the
	slots of the base to assemble the
FM 75	slots of the base to assemble the
FM 75	AM loop.
COAXIAL	AM loop.

English

AM

LOOP

AM

EXT AM Loop Antenna

123

Outdoor single vinyl-covered wire

Turn the loop until you have the best reception.

Notes:

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop antenna connected.)

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of rear speakers to enjoy the surround effect.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible DSP (Digital Signal Processor ) effect. For details, see page 11.

For each speaker (except for a subwoofer), connect the (–) and (+) terminals on the rear panel to the (–) and (+) terminals marked on the speakers. For connecting a subwoofer, see page 5.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the

speaker terminals.

1Cut, twist and remove the insulation at the end of each speaker signal cable.

2Open the terminal and then insert the speaker signal cable.

3Close the terminal.

Connecting the front speakers

You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).

Right speaker		FRONT SPEAKERS 1		Left speaker

FRONT SPEAKERS

RIGHTLEFT

1	1
2	2

Right speaker		FRONT SPEAKERS 2		Left speaker

Connecting the rear and center speakers

Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.

Center speaker		CENTER	RIGHT	LEFT
Center speaker		SPEAKER
Left rear	Right rear			REAR
speaker	speaker			REAR
speaker	speaker			SPEAKERS

4

Image 7

Contents RX-5000VBK / RX-5001VGD Precaución English Español Português Table of Contents To use the Cursor control buttons q on the front panel Remote ControlParts Identification Front PanelGetting Started Before InstallationConnecting the FM and AM Antennas Checking the Supplied AccessoriesConnecting the rear and center speakers Connecting the SpeakersAM Antenna ConnectionsBasic connecting procedure Connecting the front speakersIf your audio components have a Compu LINK-3 terminal Connecting Audio/Video ComponentsConnecting the subwoofer speaker Audio component connectionsVideo component connections Replace the cover Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletBasic Operations Turning the Power On and Off StandbySelecting the Source to Play Recording a Source Adjusting the VolumeMuting the Sound Selecting the Front SpeakersReinforcing the Bass Attenuating the Input SignalAdjusting the Front Speaker Output Balance Adjusting the ToneSetting Center and Rear Speakers for DSP Modes Basic SettingsChanging the Source Name Using the Sleep Timer Storing the Basic Settings Adjustments One Touch OperationReceiving Radio Broadcasts Setting the AM Tuner Interval SpacingUsing Preset Tuning Tuning in Stations ManuallyPress FM Selecting the FM Reception ModePress Multi Cursor @/ #to select a preset channel station Press FM/AMDolby Surround Using the DSP Modes3D-PHONIC modes Surround ModesRear Available DSP Modes According to the Speaker ArrangementFront Rear SpeakerAdjusting the DAP Modes Adjusting the 3D-PHONIC ModesRear speaker output level Press Rearl / + to adjustPress Test to check the speaker Output balanceOnly for JVC Theater Repeatedly until -CENTER+ Appears on the displayActivating the DSP Modes Select and play a sound sourceRepeatedly until -REAR L+ Using the DVD Multi Playback ModeActivating the DVD Multi Playback Mode Press DVD MultiAutomatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Same timeTuner Operating JVC’s Audio/Video ComponentsSound control section Amplifier Cassette deckDVD player CD player-changer7/P MD recorderProblem Possible Cause Solution TroubleshootingVideo SpecificationsAmplifier AudioAM tuner FM tuner IHFGeneral Precaución para la línea de la red CA Precaução para a ligação à tensão da rede CA