Weider WBTL13608.0 user manual Ceiver so the small cylinder is oriented as shown

Page 10

11. Place the treadmill in the storage position (see HOW TO	11
FOLD THE TREADMILL FOR STORAGE on page 23).	11
Center the Frame (48) between the Uprights (73, 74).		48
Tighten the Upright Bolts (72) in the lower ends of the		48
Uprights (73, 74).		74
	73	74
	73

72

72

12.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 26). To protect the floor or carpet, place a mat under the treadmill.

If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re- ceiver included with the chest pulse sensor.

1.	Make sure that the power cord is unplugged. Remove
	the indicated Console Back Screw (67) and the Access			69
	Door (70) from the left side of the Console Back (69).			69
2.	Connect the wire on the receiver (A) to the indicated wire		Small
	extending from the Console Back (69). Hold the re-		Screws	Small
	ceiver so the small cylinder is oriented as shown.			Small
	Attach the receiver to the plastic posts on the Access			Cylinder
3.	Door (70) with the two included small screws.	Wire	A
3.	Make sure that no wires are pinched. Reattach the	Wire	A
	Access Door (70) with the Console Back Screw (67). The
	other wires included with the receiver may be discarded.		70	67
			70	67

10

Image 10

Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. WBTL13608.0 Serial No On the WEBTable of Contents Trends in general Important PrecautionsSpeed, accelerate, or stop unexpectedly Never leave the treadmill unattended while itPage Back Before YOU BeginFront Right SideAssembly Tighten the Upright Bolts yet Lower the Uprights to the floor see the inset drawingSee the two small inset drawings. Using your fingernail Careful to avoid losing the Shock PinPage Make sure that no wires are pinched. Reattach Ceiver so the small cylinder is oriented as shownTreadmill Operation HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Features of the Console HOW to Turn on the PowerInsert the key into the console HOW to USE the Manual ModeSelect the manual mode Set a workout goal if desiredPage Measure your heart rate if desired Avoid moving your hands. WhenAdjust the program settings if desired HOW to USE a Preset ProgramPress the Start button to start the program Follow your progress with the matrix and the displays Select one of the custom programs HOW to USE a Custom Program HOW to USE a Heart Rate Program Select a heart rate programFollow your progress with the matrix and the displays Information MODE/DEMO Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useUnplug the Power CORD. If the walking Gap between the Magnet and the Reed Switch isProblem The walking belt slows when walked on Key and Unplug the Power CORD. UsingWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Page Part LIST-Model No. WBTL13608.0 Key No. Qty DescriptionQty Description DRAWING-Model No. WBTL13608.0 Exploded DRAWING-Model No Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT