Weider 831.153933 instruction

39.Route the Leg Lever Cable (75) under a 4 1/2” Pulley (119). Attach the Pulley and a Large Cable Trap (121) to the indicated side of the Butterfly Upright (3) with a 3/8” x 3 3/4” Bolt (122), a 3/8” Washer (91), and a 3/8” Nylon Jamnut (113). Make sure that the Large Cable Trap is turned to hold the Cable in the groove of the Pulley.

40.Wrap the Leg Lever Cable (75) over a 3 1/2” Pulley

(78).Attach the Pulley to the Double “U”-bracket

(62)with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

41.Remove the preattached 3 1/2” Pulley (not shown) from the “U”-bracket (64).

Attach the end of the Leg Lever Cable (75) to the “U”-bracket (64) with a 1/4” Washer (97) and a 1/4” Nylon Locknut (34). Note: Do not completely tighten the Locknut; it should be threaded onto the end of the Cable so that two threads show past the Locknut (see inset drawing).

42.Locate the Swivel Low Cable (72), which is the only remaining cable that has an eyelet on one end and a ball on the other end. Route the eyelet end of the Cable through the cage on the Long Base (120) and through the Swivel Upright (5) as shown.

Attach a 3 1/2” Pulley (78) to the indicated bracket on the Long Base (120) with 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

43.Wrap the Swivel Low Cable (72) under a 3 1/2” Pulley (78). Attach the Pulley to the indicated brack- et on the Long Base (120) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

39
	119
122
121
	3
	75
	91	113
40
	93
	87
	62
	75
	78
41
75		75
64		75
97
34
		34
42
78
72
Cage	87
	87
120	5
93	5
43
	72
78
120	87
93	87
93