7.Press a 2” x 3” Inner Cap (58) into the top of the Squat Upright (4). Slide the Squat Upright onto the two indicated 5/16” x 2 1/2” Carriage Bolts (110) in the Long Base (120). Finger tighten a 5/16” Nylon Locknut (86) onto each Carriage Bolt. Do not tight- en the Nylon Locknuts yet.
Press a 2” x 3” Inner Cap (58) into the top of the Swivel Upright (5). Slide the Swivel Upright onto the two indicated 5/16” x 2 1/2” Carriage Bolts (110) in the Long Base (120). Finger tighten a 5/16” Nylon Locknut (86) onto each Carriage Bolt. Do not tight- en the Nylon Locknuts yet.
8.Press two Swivel Bushings (66) into the Swivel Carriage (46).
Tighten an Adjustment Handle (65) into the Swivel Carriage (46). Orient the Swivel Carriage as shown. Slide the Carriage onto the Swivel Upright (5) and engage the Adjustment Handle into an adjustment hole in the Swivel Upright.
7 | 58 |
|
|
| |
| 58 |
|
| 5 |
|
| 4 |
|
| 86 |
|
110 | 120 | 86 |
| ||
| 110 |
|
8 | 66 |
|
|
| |
| 46 |
|
| 65 |
|
| 66 |
|
| 5 |
|
| Adjustment |
|
| Hole |
|
8