Weider 831.153933 user manual

49.Wrap the Swivel Low Cable (72) over a 3 1/2” Pulley (78). Attach the Pulley and a Cable Trap (68) between the lower set of holes in the “U”-bracket (64) with a 3/8” x 2” Bolt (100) and a 3/8” Nylon Locknut (87). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

50.Attach the end of the Swivel Low Cable (72) inside of the Short Base (2) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).

51.Locate the Squat Cable (73), which is the only remaining cable. Attach the eyelet end of the Cable inside of the Long Base (120) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).

52.Wrap the Squat Cable (73) over a 3 1/2” Pulley

(78).Attach the Pulley, a Cable Trap (68), and two 3/4” Spacers (124) between the indicated brackets on the Squat Slider (38) with a 3/8” x 3 1/4” Bolt

(96)and a 3/8” Nylon Jamnut (113). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

18

49
100		64
68
		87
72
		78
50
86 90
72	90	59
2
51
	73
		86
		90
		120
90
59
52
68 124
78		113
124
		38
	96
73