Weider 831.159822 user manual

21.Wrap the High Cable (45) around a 90mm Pulley (38). Attach the Pulley at the forward hole, inside of the bracket on the Center Top Frame (14) with an M10 x 45mm Bolt (66) and an M10 Nylon Locknut (70).

22.Attach the end of the High Cable (45) to the Small “U”-Bracket (79) with an M6 Nylon Locknut (26). Note: Do not completely tighten the

Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing.

Attach the Small “U”-Bracket (79) to the Weight Tube (82) with an M8 x 45mm Bolt (69) and an M8 Nylon Locknut (71). Do not overtighten the

Locknut; the Weight Tube should be able to pivot in the “U”-Bracket.

23.Locate the Leg Press Cable (95). Attach the Cable inside the Left Leg (36) with an M10 x 70mm Bolt (100), two M10 Washers (50), two Long Spacers (80), and an M10 Nylon Locknut (70).

24.Wrap the Leg Press Cable (95) around a 90mm Pulley (38). Attach the Pulley inside the Leg Press Frame (30) with an M10 x 70mm Bolt (100), two M10 Washers (50), two 13mm Spacers (34), and an M10 Nylon Locknut (70).

21	70
		14
		45
		38
		66
22
	45
79	71
		45
69	26
	82
			26
23
		50	70
100	80
		80
		95
50	36
24
	38	50
			70
34		34
50		95
	30
100

12