Weider 831.159822 user manual Tighten all of the M8 Nylon Locknuts 71 used in steps

11.Press the two Weight Guide Bushings (44) into the Center Top Frame (14). Slide the Center Top Frame onto the Weight Guides (20).

Attach the Center Top Frame (14) to the Right Top Frame (8) with two M8 x 70mm Bolts (81), two M8 Washers (75), and two M8 Nylon Locknuts (71).

Attach the Center Top Frame (14) to the Left Top Frame (3) with two M8 x 70mm Bolts (81), two M8 Washers (75), and two M8 Nylon Locknuts (71).

Tighten all of the M8 Nylon Locknuts (71) used in steps 3–11.

ARM ASSEMBLY

12.Press a 38mm Square Inner Cap (41) into the Right Upright (6). Press a 50mm x 63mm Inner Cap (22) into the Butterfly Frame (9).

Lubricate an M10 x 80mm Bolt (61) with grease. Attach the Butterfly Frame (9) to the Right Top Frame (8) with the Bolt and an M10 Nylon Locknut (70). Do not overtighten the Locknut; the

Butterfly Frame must be able to pivot easily.

13.Lubricate an M10 x 55mm Bolt (89) with grease. Attach the Pivot Bracket (48) to the Right Butterfly Arm (11) with the Bolt and an M10 Nylon Locknut (70). Do not overtighten the Locknut; the Pivot

Bracket must be able to pivot easily.

Press a 38mm x 50mm Inner Cap (23) into the indicated end of the Right Butterfly Arm (11). Wet the lower end of the Arm with soapy water. Slide a Large Foam Pad (19) onto the Arm.

Slide a Foam Grip (76) onto a Press Handle (12). Press a 25mm Round Inner Cap (24) into the end of the Handle. Attach the Handle to the Right Butterfly Arm (11) with two M8 x 16mm Button Head Bolts (64) and two M8 Washers (75).

Slide the Large Foam Pad (19) down so that the bottom of the Foam Pad is even with the lower end of the Right Butterfly Arm (11).

Repeat this step with the Left Butterfly Arm (10).

9

11
	71	44	71
14
81	71		71		81
75				75
8					75
	20				3
12			8
	22
			41
70		Lubricate			6
		61
9
13			89
Lubricate
			48
	11		23
	64
75		70
64	24
75				10
19
	76
	12