Weider 831.159822 user manual 100

25.Route the Leg Press Cable (95) through the Left Leg (36) and the Left Upright (7) as shown. Wrap the Cable around a 90mm Pulley (38). Attach the Pulley inside the Upright with an M10 x 70mm Bolt (100), two M10 Washers (50), two 13mm Spacers (34), and an M10 Nylon Locknut (70).

26.Wrap the Leg Press Cable (95) around a 90mm Pulley (38). Attach the Pulley inside the bracket on the Left Top Frame (3) with an M10 x 45mm Bolt (66) and an M10 Nylon Locknut (70).

27.Attach the end of the Leg Press Cable (95) to the “U”-Bracket (85) with an M6 Nylon Locknut (26).

Note: Do not completely tighten the Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset draw- ing.

28.Locate the Butterfly Cable (46). Attach the Cable to the Pivot Bracket (48) on the Left Butterfly Arm (10) with an M8 x 20mm Shoulder Bolt (78) and an M8 Nylon Locknut (71).

25
38		70
34
	50
50
34
7
95
100	36
26
3
		70
66
38
95
27
95
	95
26
85		26
28
	71
		46
10	48	78

13