Weider PRO 375 user manual Nylon Locknut the Backrest must be able to pivot freely

Page 13

28.Attach the Backrest (69) to the Backrest Frames (78) with four M6 x 36mm Screws (62) and four M6 Washers (81). Make sure that the Backrest is oriented as shown. Do not tighten the Screws yet.

29.Lubricate an M10 x 180mm Bolt (76). Attach the Backrest Frames (78) to the Bench Frame (63) with the Bolt, two M10 Small Washers (6), and an M10 Nylon Locknut (11). Do not overtighten the

Nylon Locknut; the Backrest must be able to pivot freely.

Pull the Bench Knob (80) out as far as it will go. Slide the Backrest Bracket (53) into the indicated slot on the Bench Frame (63). Engage the Bench Knob into an adjustment hole in the Backrest Bracket.

Tighten the M10 Nylon Locknuts (11) and the M6 x 36mm Screws (62) used in steps 27 and 28.

30.Attach the Seat (68) to the Bench Frame (63) with four M6 x 16mm Screws (61). Make sure that the Seat is oriented as shown.

31.Press two 19mm Round Inner Caps (66) into each of the three Pad Tubes (88). Slide the Pad Tubes through the indicated holes in the Front Leg (73) and the Leg Lever (72).

Slide two Foam Pads (65) onto each Pad Tube (88).

28

 

69

78

Wide

81

End

 

81

62

81

62

62

 

29

 

Lubricate

78

 

6

 

76

 

80

 

63

 

53

6 11

 

30

 

Wide

 

End

 

68

 

 

63

 

61

31

 

65

73

 

72

 

65

66

66

88

 

88

66

66

65

 

 

65

13

Image 13
Contents Model No. WEBE29320 Serial No QUESTIONS?Customer HOT Line Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Important Precautions Right Side Before YOU BeginMake Things Easier for Yourself AssemblyLocknuts yet Locknuts yet Tighten the M8 x 20mm Screws 50 used in steps 6 Make sure the Safety Spotters are oriented exactly as shownAngled End Weight Tube Bracket Nylon Locknut the Pulley must be able to Turn freely Tighten all M10 Nylon Locknuts 11 used StepsPage Nylon Locknuts yet Tighten the M10 Nylon Locknuts 11 used in steps Nylon Locknut the Backrest must be able to pivot freely 4661 Using the Locking BAR AdjustmentsUsing the Safety Spotters Using the LEG Lever Attaching Weights to the Barbell or the Weight CarriageTightening the Cables Locknut the Pulley must turn freelyAttaching the Curl PAD Adjusting the BackrestExercise Guidelines Cooling Down Muscle ChartStaying Motivated Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT M6 x 36mm Bolt Part Identification ChartQty Description Part LIST-Model No. WEBE29320Exploded DRAWING-Model WEBE29320