Weider PRO 375 user manual Nylon Locknuts yet

21.Attach the indicated end of the Low Cable (8) to the bracket on the Rear Base (3) using an M10 x 20mm Bolt (26) and an M10 Nylon Locknut (11).

22.Press two 50mm x 70mm Inner Caps (60) into the ends of the Stabilizer (87).

Attach the Stabilizer (87) to the Bench Frame (63) with two M10 x 60mm Carriage Bolts (64) and two M10 Nylon Locknuts (11). Do not tighten the

Nylon Locknuts yet.

Note: The indents around the holes in the Stabilizer (87) should be on the bottom, and the decal should be in the indicated location.

23.Press two 50mm Square Inner Caps (10) into the ends of the Front Leg Base (89).

Attach the Front Leg (73) to the Front Leg Base (89) using the two Front Leg Plates (90), four M10 x 70mm Bolts (85), and four M10 Nylon Locknuts (11). Do not tighten the Nylon

Locknuts yet.

21
	8
	Bracket
		3
		11
		26
22
		11
	63
	60
	87	Decal
	Indents
	64	60
23
		73
89	90
		11
10
85
85	10

11