Weider WEEVSY87210 user manual Be sure that the 5/16 x 5 Bolt 68 is tight Ened

CABLE ASSEMBLY

16. Route the Long Cable (23) around the “V”-	16
Pulley (6) on the Right Arm (48). Be sure that
the Cable is in the groove of the “V”-Pulley
and that the Long Cable Trap (50) is turned			50	7
to hold the Cable in place. Tighten the 3/8” x		68
				6
2 1/2” Bolt (7) and the 3/8” Nylon Locknut (not
shown).		20
Route the Long Cable (23) around the 3 1/2”		66
Pulley (15) attached to the Pulley Bracket (20).
		21
Be sure that the Cable is in the groove of				48
the Pulley and that the Cable Trap (66) is		15
turned to hold the Cable in place. Tighten
the 3/8” Nylon Locknut (21) and the 3/8” x 2”		23
Bolt (not shown).
Be sure that the 5/16” x 5” Bolt (68) is tight-
ened.
17. Refer to the inset drawing. If the 3 1/2” Pulley	17
(15) is pre-attached to the Long “U” Bracket
(57), remove it. Wrap the Long Cable (23)
around the 3 1/2” Pulley. Attach the Pulley and
two Pulley Covers (89) to the indicated hole in
the Long “U”-Bracket (57) with a 3/8” x 2” Bolt
(12) and a 3/8” Nylon Locknut (21). Make sure		15
that the Pulley Covers are turned so the
				23
wide tabs are on the indicated side.		23
Be sure that the Cable is in the groove of		15
the Pulley and that the Cable and Pulley	89			57
move smoothly.	Wide
	Tabs
	21
	57	12
	11