FRAME ASSEMBLY
2.Slide the Front Upright (42) onto the 5/16” x 2 1/2” Carriage Bolts (1) in the Base (4). Hand tighten a 5/16” Nylon Locknut (3) onto each Carriage Bolt. Do not tighten the
Nylon Locknuts yet.
Press a 1” Square Inner Cap (65) into the Front Upright (42).
Attach the slotted end of the Brace (87) to the 5/16” x 2 1/2” Carriage Bolt (1) in the Stabiliser (5). Hand tighten a 5/16” Nylon Locknut (3) onto the Bolt. Do not tighten the
Nylon Locknut yet.
Attach the other end of the Brace (87) to the Rear Upright (56) with a 5/16” x 2 3/4” Bolt (11), a 5/16” Washer (8), and a 5/16” Nylon Locknut (3). Do not tighten the Nylon
Locknut yet.
3.Press a 2” Square Inner Cap (27) into the end of the Top Frame (55). Press a 1 3/4” Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press two 1” Round Inner Caps (49) into the top of the crossbar.
Attach the Top Frame (55) to the Front Upright
(42)and the Rear Upright (56) with four 5/16” x 2 3/4” Bolts (11), four 5/16” Washers (8), and four 5/16” Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 1 through 3.
4.Press two 1 1/2” Bushings (82) into the Left Pedal (79). Attach a Pedal Cover (81) to the Left Pedal with a 1/2” Metal Screw (77).
Assemble the Right Pedal (not shown) in the same manner.
2 |
|
|
|
|
| 42 |
|
56 | 8 |
|
|
11 | 3 |
| |
|
| ||
|
|
| 65 |
3 |
|
|
|
87 |
|
|
|
|
| 3 |
|
| 5 |
|
|
1 |
|
| 4 |
|
|
| |
Slot |
| 1 |
|
3 | 11 |
|
|
| 11 |
| |
|
|
| |
27 | 8 | 8 |
|
| 44 | ||
|
| ||
| 55 |
|
|
|
| 49 |
|
| 44 | Crossbar |
|
|
|
| |
3 |
|
|
|
56 | 3 | 42 |
|
|
| ||
|
|
| |
4 |
|
|
|
|
| 77 |
|
|
|
| 81 |
| 79 |
|
|
82 |
|
|
|
6