Weider WEEVSY87210 user manual Frame Assembly

FRAME ASSEMBLY

5.Lubricate the pedal axles on the Rear Upright (56). Slide the Left Pedal (79) onto the left pedal axle, and the Right Pedal (78) onto the right pedal axle. Note: Make sure that the

Pedals are on the correct sides; the slot- ted brackets must be on the insides of the Pedals. Hold a 1" Retainer (69) and a 1" Round Cover Cap (70) against the end of the left pedal axle. The teeth on the Retainer must bend outward (see the inset drawing). Tap the Retainer and the Round Cover Cap onto the pedal axle. Attach the Right Pedal in the same manner.

6.Lubricate the cylinder axles on the Rear Upright (56). Slide a 5/8” Spacer (86) and a Resistance Cylinder (80) onto each cylinder axle. Be sure that the decals on the

Resistance Cylinders are facing the pedals and that the Spacer is turned as shown in the inset drawing. Hold a 5/8" Retainer (84) and a 5/8" Round Cover Cap (85) against the end of the right cylinder axle. The teeth on the Retainer must bend outward (see the inset drawing). Tap the Retainer and the Round Cover Cap onto the cylinder axle.

Tap a 5/8" Retainer (84) and a 5/8" Round Cover Cap (85) onto the left cylinder axle in the same manner.

7.Raise the Left Pedal (79) and rest it on the hook at the lower end of the left Resistance Cylinder (80). The hook must be in one of the slots under the Left Pedal.

Raise the Right Pedal (78) and rest it on the hook at the lower end of the right Resistance Cylinder (80). Make sure that the hooks are in the same position under both Pedals.

8.Set two Weight Bumpers (19) onto the brack- et on the Base (4) as shown.

Stack six Weights (25) onto the Weight Bumpers (19). Make sure that the Weights are turned so the pin grooves are all on the same side.

5
56		78	Slotted
			Brackets
Lubricate			79
69	70		69
			70
56
6
85	86	56
		Lubricate
84		80
80				86
		85	80
		84	56
7
80
78
			79
8			25
			Pin Groove
19
4—Bracket

7