Weider WEEVSY87210 user manual

Page 16

28.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in HOW TO USE THE WEIGHT SYSTEM, beginning on page 17.

Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 22 for proper cable routing. If there is any slack in the cables, the cables should be tightened. See TROUBLESHOOTING AND MAINTENANCE.

16

Image 16

Contents QUESTIONS? Model No. WEEVSY87210 Serial NoTable of Contents Important PrecautionsPage Before YOU Begin Using the weight system. If you have additionalFor your benefit, read this manual carefully before Assembly Frame AssemblyFollowing Tools not Included are Required for Assembly Do not tighten the Nylon Locknuts yetNylon Locknuts yet Nylon Locknut yetLocknut yet Tighten all Nylon Locknuts used in steps 1 throughFrame Assembly Sure that the holes in the Weight Guides Frame Assembly ARM AssemblyAre at the top, as shown Axle-Lubricate Cable Assembly Be sure that the 5/16 x 5 Bolt 68 is tight Ened Cable Assembly Be sure that the Cable is routed Around the Pulley as shown Assembly SeatSeat Assembly PinPage HOW to USE the Weight System Changing the Weight SettingAttaching the LEG Lever to the LOW Pulley Station Attaching and Removing the SeatChanging the Stepping Resistance Locking the Weight Stack Weight Resistance Chart Tightening the Cables Troubleshooting and MaintenanceReplace all cables every two years Long Cable 23 TOP View Cable DiagramShort Cable Page Ordering Replacement Parts Remove this Part Identification Chart from the Manual Page X 2 1/2 Screw Remove this Part LIST/EXPLODED Drawing from the Manual Save this Part LIST/EXPLODED Drawing for Future ReferencePart LIST-Model No. WEEVSY87210 Qty DescriptionDrawing