Cable Assembly

18.Route the Long Cable (23) around the 3 1/2” Pulley (15) attached to the bracket on the Top Frame (55). Tighten the 3/8” x 2” Bolt (12) and the 3/8” Nylon Locknut (21). (Note: This

Pulley is pre-assembled. It has been shown disassembled for easy part identifi- cation.) Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

19.Remove the 3 1/2” Low Pulley (88) from the Press Frame (17). Re-attach the Pulley with a 5/8” x 9/16” Spacer (73) between the Pulley and the Press Frame. Finger tighten the 3/8” Nylon Locknut (21).

Route the Short Cable (58) under the 3 1/2” Low Pulley (88) attached to the lower hole in the Press Frame (17). Be sure that the end of the Cable with the ball is on the indicat- ed side of the Press Frame and that the Cable is between the Pulley and the cross- bar on the Press Frame. Tighten the 3/8” Nylon Locknut (21).

If the indicated 3 1/2” Pulley (15) is pre- attached to the Front Upright (42), remove it. Route the Short Cable (58) around the Pulley. Attach the Pulley and two Pulley Covers (89) to the lower hole in the Front Upright with the 3/8” Nylon Jam Nut (92), the 3/8” Washer (9) and the 3/8” x 3 3/4” Bolt (71).

18
		23		12
	Bracket			12
	Bracket
	55		15
			15
	21
19
	89
				71
	9	15
	9			9
				9
			58
	42			73
92		Ball	21	88
			21
	Crossbar
	17