Weider WEEVSY87210 user manual Seat Assembly, Pin

Page 15

SEAT ASSEMBLY

25.Press a 1 1/2” Square Inner Cap (32) into the Leg Lever (29).

Lubricate the 5/16” x 2 1/4” Bolt (33). Attach the Leg Lever (29) to the Seat Frame (36) with the 5/16” x 2 1/4” Bolt and a 5/16” Nylon Locknut (3).

Insert the 3/8” x 2” Eyebolt (35) into the Leg Lever (29) from the direction shown. Tighten a 3/8” Nylon Locknut (21) with a 3/8” Washer

(9)onto the Eyebolt.

26.Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat Frame to the Front Upright with a 5/16” x

2 3/4” Carriage Bolt (14) and the Seat Knob

27.Press 3/4” Round Inner Caps (34) into the ends of both 12 1/2” Pad Tubes (28).

Insert one 12 1/2” Pad Tube (28) into the Seat Frame (36). Slide a 5 1/2” Pad (30) onto each end of the Pad Tube.

Insert the other 12 1/2” Pad Tube (28) into the Leg Lever (29). Slide a 5 1/2” Pad (30) onto each end of the Pad Tube.

15

25

 

 

36

33—Lubricate

3

 

 

29

35

8

 

32

3

26

 

40

 

 

36

14

 

Pin

 

42

 

27

 

 

34

36

30

 

 

28

29

 

30

 

 

34

Image 15
Contents Model No. WEEVSY87210 Serial No QUESTIONS?Important Precautions Table of ContentsPage Using the weight system. If you have additional Before YOU BeginFor your benefit, read this manual carefully before Do not tighten the Nylon Locknuts yet AssemblyFrame Assembly Following Tools not Included are Required for AssemblyTighten all Nylon Locknuts used in steps 1 through Nylon Locknuts yetNylon Locknut yet Locknut yetFrame Assembly Frame Assembly ARM Assembly Sure that the holes in the Weight GuidesAre at the top, as shown Axle-Lubricate Cable Assembly Be sure that the 5/16 x 5 Bolt 68 is tight Ened Cable Assembly Be sure that the Cable is routed Around the Pulley as shown Seat AssemblyPin Seat AssemblyPage Changing the Weight Setting HOW to USE the Weight SystemAttaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationChanging the Stepping Resistance Locking the Weight Stack Weight Resistance Chart Troubleshooting and Maintenance Tightening the CablesReplace all cables every two years Cable Diagram Long Cable 23 TOP ViewShort Cable Page Ordering Replacement Parts Remove this Part Identification Chart from the Manual Page X 2 1/2 Screw Save this Part LIST/EXPLODED Drawing for Future Reference Remove this Part LIST/EXPLODED Drawing from the ManualQty Description Part LIST-Model No. WEEVSY87210Drawing