ARM Assembly Cable Assembly | Weider WESY96352 instruction

ARM ASSEMBLY

CABLE ASSEMBLY

15.See the inset drawing. Attach the Military Press Arm (84) to the Pivot Arm (101) with two 5/16” x 2 1/4” Bolts (33) and two 5/16” Nylon Locknuts (3).

Press two 1 1/2” Square Inner Caps (32) into the indicated end of the Military Press Arm (84). Press two 1” Round Inner Caps (49) into the Military Press Arm. Slide two 5” Plastic Grips (83) onto the Military Press Arm.

Attach the Military Press Arm (84) to the VKR Upright (74) with a 3/8” x 3 1/4” Bolt (67) and a 3/8” Nylon Locknut (21).

16.Locate and open the parts bags labeled “CABLE ASSEMBLY” and “PULLEYS.”

During steps 16 through 36, refer to the CABLE DIAGRAMS on pages 26–27 of this manual to verify proper cable routing. Before beginning this section, fully unwind the four Cables. Identify the four Cables by comparing the lengths and ends of the Cables. The approximate length of each Cable is listed (in inches) after the key number in the drawing.

IMPORTANT: While assembling the cables, do not overtighten the bolts and nuts attaching the pulleys. The pulleys must be able to turn freely.

17.Locate the High Cable (58). Wrap the High Cable around a 3 1/2” Pulley (15). Attach the Pulley to the Top Frame (55) with a 3/8” x

3 3/4” Bolt (88) and a 3/8” Nylon Locknut (21).

Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the hook.

15		32
		49
		32
21		84
		84
101		83
101
	67
74		56
	33
	101
		84
	3
16
		23—79”
		58—147”
		72—194”
		99—63”
17
	55	58
21	55
21
		88
Ball	15
	Hook