Weider WESY96352 user manual Tube is sitting in the pin grooves in the top Weight

Page 8

FRAME ASSEMBLY

7.Press a Weight Tube Bumper (64) into the end of a Weight Tube (63). Insert the Weight Tube into the front stack of Weights (25). Be sure that the pin on the Weight Tube is sit- ting in the pin grooves in the top Weight.

Lubricate the inside of the holes in a Top Weight (65). Set the Top Weight onto the front stack of Weights (25). Insert both Long Weight Guides (62) into the stack of Weights.

Be sure that the holes in the Weight Guides are at the top, as shown.

8.Press a Weight Tube Bumper (64) into the end of the other Weight Tube (63). Insert the Weight Tube into the rear stack of Weights (25). Be sure that the pin on the Weight

Tube is sitting in the pin grooves in the top Weight.

Lubricate the inside of the holes in the other Top Weight (65). Set the Top Weight onto the rear stack of Weights (25). Insert both Short Weight Guides (73) into the stack of Weights.

Be sure that the holes in the Weight Guides are at the top, as shown.

8

7	Holes
	Holes
	62
	65
	Lubricate
	Pin
	63
	64
	Pin Grooves
	25
8	Holes
	Holes
	73
	Lubricate
	65
	Pin
	63
	64
	Pin Grooves
	25

Image 8

Contents Customer HOT Line QUESTIONS?Model No. WESY96352 Serial No Table of Contents Important Precautions Dimensions Before YOU Begin Assembly Frame Assembly Following Tools not Included are Required for Assembly Frame AssemblyNylon Locknuts yet Tighten all Nylon Locknuts used in steps Tube is sitting in the pin grooves in the top Weight Locate and open the parts bag labeled ARM Assembly ARMBushings should fit on each end of the indi Cated tube in the Base. Make sure thatARM Assembly Do not tighten the Nylon Locknut yetARM Assembly Cable Assembly Long Cable Trap is positioned to hold Cable in place Nylon Locknut the Pulley Bracket Must be able to move freelyCable Assembly Locate the Low Cable 23. Route the Low Locate the Military Press Cable 72. Attach Cable Assembly Pulley move smoothly Cable Assembly Seat Assembly Locate and open the parts bag labeled Seat AssemblySeat Assembly Seat Assembly VKR Assembly Locate and open the parts bag labeled VKR AssemblyWeider HOW to USE the Home GYM System Changing the Weight SettingAttaching the LEG Lever to the LOW Pulley Station Adjusting the LEG Press PlateAttaching and Removing the Seat Weight Resistance Chart PlatesTroubleshooting and Maintenance Tightening the CablesCable Diagrams TOP ViewMilitary Press Cable 72 and Leg Press Cable Pivot Arm Leg Press CablePage Page Page Part LIST-Model No. WESY96352 WESY96352 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty