Weider WESY96352 user manual Arm, Locate and open the parts bag labeled ARM Assembly

FRAME ASSEMBLY

ASSEMBLY

9.Attach the upper ends of the Short Weight Guides (73) to the Top Frame (55) with a 5/16” x 6” Bolt (60), two 1/2” x 3/4” Spacers (61), and a 5/16” Nylon Locknut (3).

Attach the upper ends of the Long Weight Guides (62) to the Top Frame (55) with a 5/16” x 6” Bolt (60), two 1/2” x 3/4” Spacers (61), and a 5/16” Nylon Locknut (3).

10.Locate and open the parts bag labeled “ARM ASSEMBLY.”

Be sure there is a Bushing (98) in each side of the Stabilizer (5). Press a 2” Square Inner Cap

(27)into each end of the Leg Press Arm (96).

Lubricate a 3/8” x 3 1/4” Bolt (67). Attach the Leg Press Arm (96) to the Stabilizer (5) with the Bolt and a 3/8” Nylon Locknut (21). Do not over- tighten the Nylon Locknut. The Leg Press Arm must be able to pivot freely.

Align the welded tubes on the Leg Press Plate

(95) with one set of holes in the Leg Press Arm

9	61	3	61
			3
	60		55

73 60

62

10		95	27
			Welded
			Tube
	96		97
		21	27
			67—Lubricate
	5	27
		98

ARM

(96). Attach the Leg Press Plate to the Leg

Press Arm with the Press Pin (97).

11. Press a 1” x 7/8” Plastic Bushing (90) onto

each welded spacer on the Press Frame (17).

Slide the Press Frame into place onto the Base

(4). Note: This will be a tight fit. The Plastic

Bushings should fit on each end of the indi-

cated tube in the Base. Make sure that the

pulleys are on the side shown.

Lubricate the 3/8” x 8” Bolt (59). Attach the

Press Frame (17) to the Base (4) with the Bolt

and a 3/8” Nylon Locknut (21).

11

21

4 Tube

17 Pulleys must be on this side

59—Lubricate

Welded Spacers

90

9