Weider WESY39523 user manual Trap is turned to hold the Cable in the groove of the Pulley

29.Wrap the Lat Cable (88) around a 90mm Pulley

(78).Attach the Pulley and a Long Cable Trap (102) to the Top Frame (6) with an M10 x 50mm Bolt

(100)and an M10 Nylon Locknut (87). Make sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.

30.Remove the preattached 90mm Pulleys (78) from the Pulley Plates (63).

Wrap the Lat Cable (88) around a 90mm Pulley

(78).Attach the Pulley and a Cable Trap (68) to the second set of holes from the top of the Pulley Plates (63) with an M10 x 50mm Bolt (100) and an M10 Nylon Locknut (87). Make sure the Cable

Trap is turned to hold the Cable in the groove of the Pulley.

31.Attach the end of the Lat Cable (88) inside of the Butterfly Top Frame (7) with an M10 x 65mm Bolt (18), two M10 Washers (91), and an M10 Nylon Locknut (87).

32.Locate the Butterfly Cable (69), which is the shortest Cable. Attach the Cable to the Pivot Bracket (70) on the Left Butterfly Arm (25) with an M8 x 20mm Shoulder Bolt (103) and an M8 Nylon Locknut (34).

33.Wrap the Butterfly Cable (69) over a “V”-pulley (55). Attach the Pulley and a Long Cable Trap (102) to the indicated bracket on the Butterfly Upright (3) with an M10 x 60mm Bolt (59) and an M10 Nylon Locknut (87). Make sure that the Long Cable

Trap is turned to hold the Cable in the groove of the Pulley.

14

29			88	78
		87
				102
				100
				6
30
	100
		68	78
				87
		88
		63
31	87	91
				91
				18
		7
		88
32
		34
				69
			70	103
			25
33
		3
		87	55
			102
				59
		69