Weider WESY39523 user manual

Page 21

61. Turn the Squat Backrest (35) so that the four screw

61

holes are closer to the bottom of the Squat

37

Backrest than the top. Attach the Squat Backrest to

114

the Squat Bracket (37) with four M6 x 16mm

 

Screws (114).

 

Fully tighten the Adjustment Knob (115) into the

114

Squat Bracket (37). Turn the knob on the

35

 

Adjustment Knob counterclockwise several times to

 

loosen it. Next, pull the Knob and slide the Squat

 

Bracket (37) down onto the Squat Slider (38).

 

Engage the Knob into one of the holes in the Squat

115

Slider, and then turn the Knob clockwise until it is

 

tight.

38

62.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.

Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on page 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING on page 25.

21

Image 21
Contents QUESTIONS? Model No. WESY39523 Serial NoCustomer HOT Line Table of Contents Decal Important PrecautionsBefore YOU Begin Using the weight system. If you have additionalFor your benefit, read this manual carefully before DecalAssembly Frame Assembly Do not tighten the Locknuts yet Page Assemble the other weight stack in the same way Open the parts bag labeled ARM Assembly Tighten all of the M10 Nylon Locknuts 87 used in stepsButterfly Frame must be able to pivot easily Cable Assembly 119 100 118 100 102 Trap is turned to hold the Cable in the groove of the Pulley Page Page Trap is turned to hold the Cable in the groove of the Pulley Trap is turned to hold the Cable in the groove of the Pulley Locate and open the parts bag labeled Seat Assembly Seat AssemblyRepeat this step with the other end of the Squat Arm Locknuts yetTighten all of the M10 Nylon Locknuts 87 used in this step Page Changing the Weight Setting AdjustmentsConverting the Butterfly Arms Ing any exerciseAdjusting the Squat Knee Rest Adjusting the Squat ARM, SEAT, or Butterfly BackrestWeight Resistance Chart StationLbs Top Tightening the Cables TroubleshootingCable Diagrams Lat CableButterfly Cable Swivel High Cable Squat Cable Leg Lever Swivel CableSwivel Low Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Page R0103A Part Identification CHART-Model No. WESY39523Page Page Remove this Part LIST/EXPLODED Drawing From the Manual Key Qty Description Part LIST-Model No. WESY39523Exploded