Weider WESY39523 user manual Trap is turned to hold the Cable in the groove of the Pulley

Page 18

49.Wrap the Swivel Low Cable (72) over a 90mm Pulley (78). Attach the Pulley and a Cable Trap (68) between the lower set of holes in the “U”-bracket (64) with an M10 x 50mm Bolt (100) and an M10 Nylon Locknut (87). Make sure that the Cable

Trap is turned to hold the Cable in the groove of the Pulley.

50.Attach the end of the Swivel Low Cable (72) inside of the Short Base (2) with an M10 x 65mm Bolt (18), two M10 Washers (91), and an M10 Nylon Locknut (87).

51.Locate the Squat Cable (73), which is the only remaining cable. Attach the eyelet end of the Cable inside of the Long Base (101) with an M10 x 65mm Bolt (18), two M10 Washers (91), and an M10 Nylon Locknut (87).

52.Wrap the Squat Cable (73) over a 90mm Pulley

(78).Attach the Pulley, a Cable Trap (68), and two 19mm Spacers (98) between the indicated brackets on the Squat Slider (38) with an M10 x 85mm Bolt

(96)and an M10 Nylon Locknut (87). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

18

49
100		64
68		64
68		87
72		87
72		78
		78
50
87 91
72	91	18
2
51
	73
		87
		91
		101
91
18
52
68	98
78		87
98		87
98
		38
	96
73

Image 18

Contents QUESTIONS? Model No. WESY39523 Serial NoCustomer HOT Line Table of Contents Important Precautions DecalFor your benefit, read this manual carefully before Using the weight system. If you have additionalBefore YOU Begin DecalAssembly Frame Assembly Do not tighten the Locknuts yet Page Assemble the other weight stack in the same way Open the parts bag labeled ARM Assembly Tighten all of the M10 Nylon Locknuts 87 used in stepsButterfly Frame must be able to pivot easily Cable Assembly 119 100 118 100 102 Trap is turned to hold the Cable in the groove of the Pulley Page Page Trap is turned to hold the Cable in the groove of the Pulley Trap is turned to hold the Cable in the groove of the Pulley Seat Assembly Locate and open the parts bag labeled Seat AssemblyRepeat this step with the other end of the Squat Arm Locknuts yetTighten all of the M10 Nylon Locknuts 87 used in this step Page Converting the Butterfly Arms AdjustmentsChanging the Weight Setting Ing any exerciseAdjusting the Squat ARM, SEAT, or Butterfly Backrest Adjusting the Squat Knee RestWeight Resistance Chart StationLbs Top Troubleshooting Tightening the CablesCable Diagrams Lat CableButterfly Cable Swivel High Cable Squat Cable Leg Lever Swivel CableSwivel Low Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Page Part Identification CHART-Model No. WESY39523 R0103APage Page Remove this Part LIST/EXPLODED Drawing From the Manual Part LIST-Model No. WESY39523 Key Qty DescriptionExploded