Weider WESY39523 user manual Frame Assembly

FRAME ASSEMBLY

1.

Make sure that you understand all of the information on page 5 before you begin assembling the weight system.

Locate and open the parts bags labeled “FRAME ASSEMBLY 1” and “FRAME ASSEMBLY 2.”

See the inset drawing. Attach the Base Cap (24) to the Short Base (2) with two M4 x 20mm Self-tap- ping Screws (14) and two M4 Washers (120).

Press a 50mm Square Inner Cap (105) into the open end of the Long Base (101).

Insert eight M10 x 65mm Carriage Bolts (110) up through the Long Base (101) and the Short Base

(2)as shown. Note: It may be helpful to place tape over the heads of the Carriage Bolts to hold them in place.

Attach the Short Base (2) to the Long Base (101) with two M10 x 70mm Bolts (85), the Long Frame Plate (71), and two M10 Nylon Locknuts (87).

2.Press two 50mm x 75mm Inner Caps (58) into the Foot Plate (53). Attach the Foot Plate to the Long Base (101) with two M10 x 65mm Carriage Bolts (110) and two M10 Nylon Locknuts (87).

3.Attach the tether on the Long Pin w/Tether (112) to the Long Base (101) with an M4 x 20mm Self-tap- ping Screw (14).

Attach the four Knee Rest Bumpers (108) to the Squat Knee Rest (41) with four M4 x 20mm Self- tapping Screws (14). Attach the Squat Knee Rest to the Long Base (101) with an M10 x 85mm Bolt (96) and an M10 Nylon Locknut (87). Do not overtight- en the Locknut; the Squat Knee Rest must be able to pivot.

6

1			2
		24
			120
			14
		71	85
110			101
	87
2
	87
	110
	110		110	105
2
110	53
		58
		87
				101
58	87
3
	14	112	41
		96		108
	101
	87			14
	108		108
		14