Assembly

Make Assembly Easier

Everything in this manual is designed to ensure that the weight system can be assem- bled successfully by anyone.

Before beginning assembly, make sure to read the information on this page. This brief introduction will save you much more time than it takes to read it.

Assembly Requires Two Persons

For your convenience and safety, assemble the weight system with the help of another person.

Set Aside Enough Time

Due to the many features of the weight system, the assembly process will require several hours. By setting aside plenty of time and by deciding to make the task enjoyable, assembly will go smoothly.

Select a Location for the Weight System

Because of its weight and size, the weight system should be assembled in the location where it will be used. Make sure that there is enough room to walk around the weight system as you assemble it.

How to Unpack the Box

To make assembly easier, we have divided the assembly process into four stages. The small hard- ware needed for each stage is packaged in sepa- rate bags. Important: Wait until you begin each stage to open the parts bag(s) for that stage. Place all parts of the weight system in a cleared area and remove the packing materials. Do not dis- pose of the packing materials until assembly is com- pleted.

Make sure that you have the following tools:

• Two adjustable wrenches

• One standard screwdriver

• One phillips screwdriver

• One rubber mallet

•You will also need grease or petroleum jelly, a small amount of soapy water, and masking tape.

Note: Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

How to Identify Parts

To help you identify the small parts used in assembly, a PART IDENTIFICATION CHART is included in the center of this manual. Lay the chart on the floor and use it to easily identify parts during each assembly step. Note: Some small parts may have been pre- attached. If a part is not in the parts bag, check to see if it has been pre-attached.

How to Orient Parts

As you assemble the weight system, make sure that all parts are oriented exactly as shown in the draw- ings.

Tightening Parts

Tighten all parts as you assemble them, unless instructed to do otherwise.

Questions?

If you have questions after reading the assembly instructions, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time.

	The Four Stages of the Assembly Process

	Frame Assembly—You will begin by assembling	Cable Assembly—During this stage, you will
	the base and the uprights that form the skeleton of	attach the cables and pulleys that connect the
	the weight system.	weight stations to the weight stacks.
	Arm Assembly—During this stage, you will	Seat Assembly—During the final stage, you will
	assemble the arms and the leg lever.	assemble the seat and the backrests.

ASSEMBLY