Weider WESY39523 user manual

34.Remove the preattached 90mm Pulleys (78) from the Double “U”-bracket (62).

Wrap the Butterfly Cable (69) under a 90mm Pulley

(78).Attach the Pulley to the Double “U”-bracket

(62)with an M10 x 45mm Bolt (93) and an M10 Nylon Locknut (87).

35.Wrap the Butterfly Cable (69) over a “V”-pulley (55). Attach the Pulley and a Long Cable Trap (102) to the other side of the bracket on the Butterfly Upright

(3)with an M10 x 60mm Bolt (59) and an M10 Nylon Locknut (87). Make sure that the Long

Cable Trap is turned to hold the Cable in the groove of the Pulley.

36.Attach the Butterfly Cable (69) to the Pivot Bracket

(70)on the Right Butterfly Arm (26) with an M8 x 20mm Shoulder Bolt (103) and an M8 Nylon Locknut (34).

37.Locate the Leg Lever Cable (75), which is 2505mm long and has an eyelet on one end and a threaded pin on the other end. Route the eyelet end of the Cable through the Seat Upright (9) and attach it to the tab on the Leg Lever (10) with an

M8 x 20mm Shoulder Bolt (103) and an M8 Nylon Locknut (34).

38.Attach a 90mm Pulley (78) inside of the Seat Upright (9) with an M10 x 65mm Bolt (18), two M10 Washers (91), two 12mm Spacers (89), and an M10 Nylon Locknut (87), as shown.

15

34
		69
		78
	87
	62	93
35	59
	102
	69
	55		3
			87
36	103	69
	70
	26	34
37
	34		75
			9
	10
	103
38		9
	91 89	78	75
	87
			91
		89	18