Operating Instructions
Water Cooling
| It may be necessary to cool down the water before pumping it out in |
| order to prevent thermal damage to the plastic drainage pipes. |
3 | The water is cooled down before pumping out at the end of the main |
| washing cycle (by adding cold water). |
(This setting is only active for COTTONS/LINEN with a temperature of over 40 °C.).
When the appliance is supplied from the factory, the water cooling function is not set.
Setting the water cooling function:
01. Turn the programme selector to SHORT SPIN.
2.Press the PRE WASH button for at least 5 seconds.
After the button has been pressed for 5 seconds, MAIN WASH flashes on the programme progress display for 5 seconds.
3.Release the PRE WASH button while MAIN WASH is flashing.
After it has stopped flashing, the water cooling function is set. It re- mains set until it is manually cancelled.
4.If you wish to check whether the water cooling function is set:
–Turn the programme selector to SHORT SPIN.
–Press the PRE WASH button briefly.
If the MAIN WASH indicator on the programme progress display flashes, the water cooling function is set.
Cancelling the water cooling function:
01. Turn the programme selector to SHORT SPIN.
2.Press the PRE WASH button for at least 5 seconds.
MAIN WASH flashes on the programme progress display as soon as the button is pressed. After 5 seconds, MAIN WASH stops flashing and illu- minates for 5 seconds.
3.Release the PRE WASH button while MAIN WASH is continuously illu- minated. Once MAIN WASH has ceased to be illuminated, the water cooling function is cancelled.
3 | Water cooling increases water consumption and the programme dura- |
| tion. |
Additional Rinse and Water Cooling
You can combine the additional rinse cycle and water cooling. The set- ting is performed as under "Additional rinse cycle“ and "Water cooling“.
40