Installation and connection
Installation surface
A concrete floor is the most suitable in‐ stallation surface for a washing ma‐ chine, being far less prone to vibration during the spin cycle than wooden floorboards or a carpeted surface.
Please note:
The machine must be level and se‐ curely positioned.
To avoid vibrations during spinning, the machine should not be installed on soft floor coverings.
If installing on a wooden joist floor:
We recommend a plywood base at least 59 x 52 x 3 cm). The base should span several joists and be bolted to the joist and not only the floorboards. Check for the presence of pipes and cables first.
Tip: If possible, install the machine in a corner, as this is usually the most stable part of the floor.
If the machine is installed on a raised plinth, it has to be secured against slippage during spinning us‐ ing retaining clips (available from Miele). Otherwise there is the danger of the machine moving and falling off the plinth.
Transporting the washing ma‐ chine to its installation site
To manoeuvre the washing machine out of its packing case to its installation site, hold it by the front feet as well as by the edge of the lid where it protrudes to the rear of the machine.
Ensure that the machine feet and the floor are dry to prevent the ma‐ chine from slipping during the spin cycle.
Removing the transit bars
To remove the left and right covers
1. Pull on the attached stopper,
2.then use a screwdriver to release the catches at the top and bottom.
78