JVC TH-A10R Setting speaker size, Use the 2/3cursors to select Speaker Size, Set speaker size

Speaker selection box

Press ENTER.

Note icon

Test tones will be played in the following order:

4.

See page 45, “Opening the SPEAKER MENU”.

2. Switch the speaker mode to EXPERT.

3. Move the pointer to TEST TONE using the 5/° cursors.

Open the SPEAKER MENU.

1.

SPEAKER MENU Settings

Playing a test tone

When you wish to play a test tone, make sure the sound mode is set to “SURROUND ON” or “THEATER.” The test tone will not play in other modes.

Left Front Speaker =Center Speaker =Right Front Speaker

±-

Left Rear Speaker+Right Rear Speaker

•The note icon on the screen moves to the active speaker. On the center unit, the audio channel display lamp also moves to the active speaker, and the name of the active speaker appears in the display window, reflecting the configuration of the audio channel display lamps.

•The test tone is 6.

To stop the test tone, move the pointer to TEST TONE and press

ENTER.

Note:

•The test tone stops when the pointer moves from TEST TONE while the speaker selection box displays “SPEAKER SIZE” or “DELAY”.

Settings may be entered while the tone is sounded only if the speaker selection box displays “SPEAKER LEVEL”.

Setting speaker size

1. Open the SPEAKER MENU.

See page 45, “Opening the SPEAKER MENU”.

2. Switch the speaker mode to EXPERT.

3. Move the pointer to the speaker selection box using the 5/°cursors.

Speaker selection box

46

4. Use the 2/3cursors to select SPEAKER SIZE.

Pressing the 2/3cursors toggles between the following settings.

jSPEAKER SIZEjSPEAKER LEVELjDELAYj

5. Set speaker size.

Use the 5/°cursors to move to the parameter you wish to set, then adjust the parameter with the 2/3 cursors.

The Note icon on the screen indicates the selected speaker.

Note icon

Selected parameter

Speaker parameters —————————————

Speaker size

Select LARGE when the cone speaker imbedded in the speaker being used has a diameter of 12 cm or more.

Select SMALL when the diameter is less than 12 cm.

When using this system’s front, center, or rear speakers select SMALL for each.

Selecting LARGE may result in speaker damage.

F. SP	: Sets left and right front speaker size.
	Pressing the 2/3cursors toggles between the following
	settings.
	SMALL jLARGE
C. SP	: Sets center speaker size.
	Pressing the 2/3cursors toggles between the following
	settings.
	When the F.SP is selected “SMALL”:
	SMALL jOFF
	When the F.SP is selected “LARGE”:
	j SMALL jLARGE jOFF j

•Select OFF when the center speaker is not connected, or is not in use.

R.SP : Sets rear speaker size.

Pressing the 2/3cursors toggles between the following settings.

When the F.SP is selected “SMALL”: SMALL jOFF

When the F.SP is selected “LARGE”: j SMALL jLARGE jOFF j

•Select OFF when the rear speaker is not connected, or is not in use.

CROSS OVER : When using a small speaker with weak bass as a front, center, or rear speaker, you can redirect bass audio to the sub-woofer. Select a cross over frequency to match the size of the small speaker being used.

Pressing the 2/3cursors toggles between the following settings.

200Hz j100Hz j120Hz

Cross over frequency	Speaker diameter
100Hz	approx. 10 cm (4”)
120Hz	approx. 8 cm (3-3/16”)
200Hz	approx. 4 cm (1-5/8”)

BASS : BASS is fixed for SUBWOOFER. This cannot be selected with the pointer.