1103908769 DW9150 US_110x154 27/07/11 15:41 Page3
IMPORTANT SAFETY | EN |
INSTRUCTIONS |
|
When using an iron, basic precautions should always be followed, in- cluding the following:
Read all instructions before using
1. Only use an iron for its inten- | sembly. |
ded use. | 7. Close supervision is required |
2.To avoid the risk of electric for any appliance used by or near shock, do not immerse the iron in children. Do not leave the iron
water or other liquids. | unattended while the iron is |
3.Always turn the iron OFF be- connected or on an ironing fore plugging or unplugging the board.
iron from the electrical outlet. 8. Burns can occur from touching Never pull on the cord to discon- hot metal parts, hot water, or nect the iron from the electrical steam. Use caution when you outlet; instead, grasp the plug turn a STEAM IRON upside down and pull on the plug to discon- – there might be hot water in the
nect the iron. | reservoir. |
4.Do not let the cord touch hot 9. In the event the malfunction in- surfaces. Let the iron cool com- dicator goes on, the iron is not pletely before putting the iron operating properly. Disconnect away. Coil the cord loosely the iron from the electrical outlet
around the iron when storing. | and have the iron serviced by |
5.Always disconnect the iron qualified service personnel. from the electrical outlet before 10. To avoid a circuit overload, do filling the iron with water, emp- not operate an iron on the same tying the water from the iron, and circuit with another high wattage
when the iron is not in use. | appliance. |
6.Do not operate the iron with a 11. If an extension cord is abso- damaged cord or in the event the lutely necessary, a cord with an iron has been dropped or dama- ampere rating equal to or greater ged. To avoid the risk of electric than the maximum rating of the shock, do not disassemble the iron shall be used. A cord rated iron. Take it to a qualified servi- for less amperage can result in a ceman for examination and re- risk of fire or electric shock due to pair. Incorrect assembly might overheating. Care shall be taken result in a risk of electric shock to arrange the cord so that it can- when the iron is used after reas- not be pulled or be tripped over.
3* depending on model