AEG 86740 manual How much washing detergent and care agent?, Water Softener

Page 18

Instructions for use

Washing Detergents and Care Agents

 

Which washing detergent and care agent?

 

Use only washing detergents and care agents which are suitable for use

 

in washing machines. Always follow the manufacturer's instructions.

 

How much washing detergent and care agent?

 

The amount to be used depends on:

 

• the dirtiness of the washing

 

• the hardness category of the mains water supply

 

• the filling quantity

2

If the detergent manufacturer gives no details of the dosing quantities

 

for minimum loads, add one third less for half loads and, in the case of

very small loads and for EASY IRON (STRIJKVRIJ, SANS REPASSAGE), only half the amount of detergent recommended for a full load.

Refer to the detergent/care agent manufacturer's instructions on use and dosage.

Water Softener

For medium to high water hardness (hardness category II or higher) you should use water softener. Pay attention to the manufacturer's instruc- tions. Always then meter detergent for hardness category I (= soft). The responsible water works can provide information on the local water hardness.

2

Since the water softener is added before the main washing detergent,

 

(water pre-softening), eighty percent of the softener quantity stated on

 

the package is sufficient.

 

 

 

Water Hardness Details

 

 

 

 

 

 

 

 

Water Hardness °dH

Water Hardness in mmol/l

 

Hardness Category

 

(degrees German

 

 

(millimol per litre)

 

 

 

hardness)

 

 

 

 

 

I – soft

 

0 - 7

up to 1.3

 

II – medium hard

 

7 - 14

1.3 - 2.5

 

III – hard

 

14 - 21

2.5 - 3.8

 

IV – very hard

 

over 21

over 3.8

 

 

 

 

 

18

Image 18
Contents ÖKO-LAVAMAT 86740 update Dear customer Contents Remedying Faults What to do ifPage Safety Before Putting into Operation for the First TimeCorrect Use Child Safety General SafetyDispose the packing material DisposalEnvironmental Tips For polyoxymethylene, e.g. plastic clipsUnit Description Front ViewDrawer for Washing Powder and Care Agent Control Panel Programme knobWool WOL, LAINE/ P Hand wash program Silk ZIJDE, SOIE/ P handwashAdditional programme buttons PRE Wash VOORWAS, PRELAV. Pre wash/SoakingProgrammable functions Two levels for other programmesTemperature Consumption values and time requirementsWhat does Update mean? Water Protection Aqua Control + Aqua AlarmWash Time Display Before the first wash Preparing a Wash LoadSorting and preparing a wash load Types of washing and care symbols How much washing detergent and care agent? Water SoftenerAfter completion of the wash programme Carrying out a wash cycleBrief instructions Open door, remove washingSetting the wash programme Change Spin Speed / Select Rinse Hold Setting the delay timer/soaking time Delay timer Soaking durationOpening and Closing the Filling Door Putting in the washingCompartment for powdered washing agent/Tabs When using liquid washing agent/TabsAdd Washing Detergent/Care Agent Compartment for pre-wash agent/soaking agentFor a set delay time Starting the wash programMulti display Sequence of the programmeProgramme sequence display Changing speed of spinningWash cycle ended/Remove washing Remove washing Turn programme knob to OFF UIT, ArretLights up, too much washing detergent was used Programme tables WashFashion Separate Rinsing/Conditioner/Starching/Impregnation Separate SpinningCleaning and Care Washing Detergent DrawerWashing Drum Filling DoorCleaning the drain pump Before cleaning the drain pumpRemedying Faults After remedying the fault, press the buttonWhat to do if Been removed Conditioner has not Conditioner insert Rinsed, compartment No negative effect on If there are still grey stains on the washing If the washing result is not satisfactoryIf the washing is grey and limescale forms in the drum If foam is still visible after the final rinseCarry Out an Emergency Emptying Operation Aid of the emergency unlocking facility When all the washing solution has drained offEmergency Unlocking of the Filling Door Gency unlocking and remove the plug from the mainsAdditional rinse cycle RINCAGE+ With more waterSet additional rinse cycle Cancel additional rinse cycle Setting water coolingWater cooling Cancel water cooling Additional rinse cycle and water coolingGramme duration increase Cancel loose spin Variomatic-loose spinningSet loose spin Setting programme security Programme securityReleasing the programme security Child Safety Feature Setting the Child Safety FeatureCancelling the Child Safety Feature Setting up and connection instructions Safety Instructions for InstallationWhen transporting the unit with a sack trolley Setting Up the UnitRemove the Transport Safeguard Transporting the UnitFirmly pull both hose holders off the unit Supplied with the unitPrepare the Installation Location Setting Up on a Concrete PedestalSetting Up on a Vibrating floor Compensate for Floor Unevenness Electrical Connection Water ConnectionPermissible Water Pressure Water Inflow Water Drainage Water Drainage into a SiphonDraining the water into a basin Delivery Heads over 1m Technical DataDimensions Measurements in mmGuarantee conditions BelgiumGuarantee conditions Customer services Page Page Index Service When do you incur costs even during the warranty period?AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG