AEG 86740 manual Been removed

Page 36

Instructions for use

Problem

Possible cause

Remedy

 

Transport safeguard has not

Remove transport safeguard

 

according to setting up and

 

been removed.

 

connection instructions.

 

 

 

The height adjustable

Align feet according to

 

threaded feet are not

setting up and connection

 

correctly adjusted.

instructions.

Washing machine vi-

There is very little washing in

Function is not affected by

brates during operation

the drum (e.g. only a dressing

or is unsteady.

gown).

this.

 

 

 

Water could not be fully

Move the path of the hose

 

and, if necessary, remove

 

pumped out before spinning

 

kink or clean water pump

 

because drainage hose is

 

and, if necessary, remove

 

kinked or water pump is

 

foreign body from pump

 

blocked.

 

housing.

 

 

Wash water of the

Probably too much washing

Dose washing agent exactly

mainwashing foams

according to manufacturers

agent has been filled in.

strongly.

instructions.

 

 

Connection to the inflow

Tighten inflow hose

 

hose is leaking.

connection.

 

Drainage hose is leaking.

Check drainage hose and, if

 

necessary, replace.

 

 

 

Cover of the water pump is

Close cover properly.

 

not properly closed.

 

 

Water leaks out of the

Washing is jammed

Abort programme, remove

washing from door. Start

washing machine.

in the door.

programme again.

 

 

 

 

Close off emergency empty-

 

 

ing hose (see section „Carry

 

Emergency emptying hose is

out energy emptying opera-

 

not properly closed off or is

tion“). In the case of a

 

leaking.

leaking emergency emptying

 

 

hose, call the customer

 

 

service.

The emptying pump

 

Close water tap, remove

runs continuously -

Anti-flood system Aqua Con-

electric plug and inform

also when the appli-

trol has displayed.

customer service.

ance is switched off.

 

 

 

 

 

 

36

Page 35 Page 37
Image 36
Page 35 Page 37
Contents ÖKO-LAVAMAT 86740 update Dear customer Contents Remedying Faults What to do ifPage Safety Before Putting into Operation for the First TimeCorrect Use Child Safety General SafetyDisposal Environmental TipsDispose the packing material For polyoxymethylene, e.g. plastic clipsUnit Description Front ViewDrawer for Washing Powder and Care Agent Control Panel Programme knobWool WOL, LAINE/ P Hand wash program Silk ZIJDE, SOIE/ P handwashAdditional programme buttons PRE Wash VOORWAS, PRELAV. Pre wash/SoakingProgrammable functions Two levels for other programmesTemperature Consumption values and time requirementsWhat does Update mean? Water Protection Aqua Control + Aqua AlarmWash Time Display Before the first wash Preparing a Wash LoadSorting and preparing a wash load Types of washing and care symbols How much washing detergent and care agent? Water SoftenerCarrying out a wash cycle Brief instructionsAfter completion of the wash programme Open door, remove washingSetting the wash programme Change Spin Speed / Select Rinse Hold Setting the delay timer/soaking time Delay timer Soaking durationOpening and Closing the Filling Door Putting in the washingWhen using liquid washing agent/Tabs Add Washing Detergent/Care AgentCompartment for powdered washing agent/Tabs Compartment for pre-wash agent/soaking agentFor a set delay time Starting the wash programSequence of the programme Programme sequence displayMulti display Changing speed of spinningWash cycle ended/Remove washing Remove washing Turn programme knob to OFF UIT, ArretLights up, too much washing detergent was used Programme tables WashFashion Separate Rinsing/Conditioner/Starching/Impregnation Separate SpinningCleaning and Care Washing Detergent DrawerWashing Drum Filling DoorCleaning the drain pump Before cleaning the drain pumpRemedying Faults After remedying the fault, press the buttonWhat to do if Been removed Conditioner has not Conditioner insert Rinsed, compartment No negative effect on If the washing result is not satisfactory If the washing is grey and limescale forms in the drumIf there are still grey stains on the washing If foam is still visible after the final rinseCarry Out an Emergency Emptying Operation When all the washing solution has drained off Emergency Unlocking of the Filling DoorAid of the emergency unlocking facility Gency unlocking and remove the plug from the mainsAdditional rinse cycle RINCAGE+ With more waterSet additional rinse cycle Cancel additional rinse cycle Setting water coolingWater cooling Cancel water cooling Additional rinse cycle and water coolingGramme duration increase Cancel loose spin Variomatic-loose spinningSet loose spin Setting programme security Programme securityReleasing the programme security Child Safety Feature Setting the Child Safety FeatureCancelling the Child Safety Feature Setting up and connection instructions Safety Instructions for InstallationSetting Up the Unit Remove the Transport SafeguardWhen transporting the unit with a sack trolley Transporting the UnitFirmly pull both hose holders off the unit Supplied with the unitPrepare the Installation Location Setting Up on a Concrete PedestalSetting Up on a Vibrating floor Compensate for Floor Unevenness Electrical Connection Water ConnectionPermissible Water Pressure Water Inflow Water Drainage Water Drainage into a SiphonDraining the water into a basin Technical Data DimensionsDelivery Heads over 1m Measurements in mmGuarantee conditions BelgiumGuarantee conditions Customer services Page Page Index Service When do you incur costs even during the warranty period?AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG
Top Page Image Contents