AEG 86740 manual Setting up and connection instructions, Safety Instructions for Installation

Page 48

Setting up and connection instructions

Setting up and connection instructions

Safety Instructions for Installation

•Do not tilt the washing machine onto its front or onto its right side (looking from the front). Electrical components could get wet!

•Check the washing machine for transport damage. Never connect a damaged unit. Consult your supplier in the event of damage.

•Ensure that all parts of the transport safeguard have been removed and that the splash guard is fitted to the unit, see ”Removing the Transport Safeguard”. Otherwise, damage to the unit or to adjacent furniture could occur during spinning.

•Always insert the plug into a correctly installed PE socket.

•In the case of permanent installation: A permanent installation may only be made by an authorised specialist.

•Before putting the unit into operation, ensure that the rated voltage and current type shown on the unit's rating plate are the same as the mains voltage and current type at the installation location. The re- quired electrical fuse is also shown on the rating plate.

•Should work be carried out on the water supply installations in order to allow the machine to be connected properly to the water supply, this work must be carried out by an authorised installer.

•Should work be carried out on the mains supply in order to allow the machine to be connected properly to the electricity supply, this work must be carried out by an authorised electrician.

•The mains cable may only be replaced by the Customer Service or by an authorised specialist.

48

Image 48

Contents ÖKO-LAVAMAT 86740 update Dear customer Contents Remedying Faults What to do ifPage Safety Before Putting into Operation for the First TimeCorrect Use Child Safety General SafetyDisposal Environmental TipsDispose the packing material For polyoxymethylene, e.g. plastic clipsUnit Description Front ViewDrawer for Washing Powder and Care Agent Control Panel Programme knobWool WOL, LAINE/ P Hand wash program Silk ZIJDE, SOIE/ P handwashAdditional programme buttons PRE Wash VOORWAS, PRELAV. Pre wash/SoakingProgrammable functions Two levels for other programmesTemperature Consumption values and time requirementsWhat does Update mean? Water Protection Aqua Control + Aqua AlarmWash Time Display Before the first wash Preparing a Wash LoadSorting and preparing a wash load Types of washing and care symbols How much washing detergent and care agent? Water SoftenerCarrying out a wash cycle Brief instructionsAfter completion of the wash programme Open door, remove washingSetting the wash programme Change Spin Speed / Select Rinse Hold Setting the delay timer/soaking time Delay timer Soaking durationOpening and Closing the Filling Door Putting in the washingWhen using liquid washing agent/Tabs Add Washing Detergent/Care AgentCompartment for powdered washing agent/Tabs Compartment for pre-wash agent/soaking agentFor a set delay time Starting the wash programSequence of the programme Programme sequence displayMulti display Changing speed of spinningWash cycle ended/Remove washing Remove washing Turn programme knob to OFF UIT, ArretLights up, too much washing detergent was used Programme tables WashFashion Separate Rinsing/Conditioner/Starching/Impregnation Separate SpinningCleaning and Care Washing Detergent DrawerWashing Drum Filling DoorCleaning the drain pump Before cleaning the drain pumpRemedying Faults After remedying the fault, press the buttonWhat to do if Been removed Conditioner has not Conditioner insert Rinsed, compartment No negative effect on If the washing result is not satisfactory If the washing is grey and limescale forms in the drumIf there are still grey stains on the washing If foam is still visible after the final rinseCarry Out an Emergency Emptying Operation When all the washing solution has drained off Emergency Unlocking of the Filling DoorAid of the emergency unlocking facility Gency unlocking and remove the plug from the mainsAdditional rinse cycle RINCAGE+ With more waterSet additional rinse cycle Cancel additional rinse cycle Setting water coolingWater cooling Cancel water cooling Additional rinse cycle and water coolingGramme duration increase Cancel loose spin Variomatic-loose spinningSet loose spin Setting programme security Programme securityReleasing the programme security Child Safety Feature Setting the Child Safety FeatureCancelling the Child Safety Feature Setting up and connection instructions Safety Instructions for InstallationSetting Up the Unit Remove the Transport SafeguardWhen transporting the unit with a sack trolley Transporting the UnitFirmly pull both hose holders off the unit Supplied with the unitPrepare the Installation Location Setting Up on a Concrete PedestalSetting Up on a Vibrating floor Compensate for Floor Unevenness Electrical Connection Water ConnectionPermissible Water Pressure Water Inflow Water Drainage Water Drainage into a SiphonDraining the water into a basin Technical Data DimensionsDelivery Heads over 1m Measurements in mmGuarantee conditions BelgiumGuarantee conditions Customer services Page Page Index Service When do you incur costs even during the warranty period?AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG