AEG 86740 manual What to do if, Remedying Faults, After remedying the fault, press the button

Page 35

Instructions for use

What to do if ...

Remedying Faults

In the event of a fault, try to solve the problem yourself with the aid of the information provided here. If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even dur- ing the warranty period.

• It the fault code C1 or C2 appears in the multi display, you may be able to remedy the fault yourself (see the fault table below).

After remedying the fault, press the button

START/PAUSE (START/PAUZE, MARCHE/PAUSE). If the fault code is displayed again, please inform the Customer Service.

•In the case of all other displayed faults (C and number or letter), please inform the Customer Service and state the fault code.

Problem

Possible cause

Remedy

 

Electric plug not inserted.

Insert electric plug.

 

Fuse of the mains installation

Replace fuse.

 

is not correct.

 

Washing machine does

Door is not properly closed.

Close door; Lock must en-

not function.

gage audibly .

 

 

Button: START/PAUSE

Press START/PAUSE (START/

 

(START/PAUZE, MARCHE /

PAUZE, MARCHE /PAUSE)

 

PAUSE) has not been pressed

button until the programme

 

long enough.

starts.

 

Child safety feature is

Cancel child safety feature

Door cannot be closed.

(see section „Childsafety

switched On.

 

feature“).

 

 

 

Water tap is switched Off

Open water tap.

Water is not entering.

Filter in the socket of the in-

Close water tap. Disconnect

hose from water tap, remove

Error code (1 ap-

flow hose connection is

filterand clean under

blocked.

pears.

running water.

 

 

Water tap is full of lime or

Check water tap, if necessary

 

defective.

have it repaired.

 

 

 

35

Page 34 Page 36
Image 35
Page 34 Page 36
Contents ÖKO-LAVAMAT 86740 update Dear customer Contents What to do if Remedying FaultsPage Correct Use SafetyBefore Putting into Operation for the First Time General Safety Child SafetyFor polyoxymethylene, e.g. plastic clips DisposalEnvironmental Tips Dispose the packing materialDrawer for Washing Powder and Care Agent Unit DescriptionFront View Programme knob Control PanelSilk ZIJDE, SOIE/ P handwash Wool WOL, LAINE/ P Hand wash programPRE Wash VOORWAS, PRELAV. Pre wash/Soaking Additional programme buttonsTwo levels for other programmes Programmable functionsConsumption values and time requirements TemperatureWash Time Display What does Update mean?Water Protection Aqua Control + Aqua Alarm Sorting and preparing a wash load Before the first washPreparing a Wash Load Types of washing and care symbols Water Softener How much washing detergent and care agent?Open door, remove washing Carrying out a wash cycleBrief instructions After completion of the wash programmeSetting the wash programme Change Spin Speed / Select Rinse Hold Soaking duration Setting the delay timer/soaking time Delay timerPutting in the washing Opening and Closing the Filling DoorCompartment for pre-wash agent/soaking agent When using liquid washing agent/TabsAdd Washing Detergent/Care Agent Compartment for powdered washing agent/TabsStarting the wash program For a set delay timeChanging speed of spinning Sequence of the programmeProgramme sequence display Multi displayRemove washing Turn programme knob to OFF UIT, Arret Wash cycle ended/Remove washingLights up, too much washing detergent was used Wash Programme tablesFashion Separate Spinning Separate Rinsing/Conditioner/Starching/ImpregnationWashing Detergent Drawer Cleaning and CareFilling Door Washing DrumBefore cleaning the drain pump Cleaning the drain pumpWhat to do if Remedying FaultsAfter remedying the fault, press the button Been removed Conditioner has not Conditioner insert Rinsed, compartment No negative effect on If foam is still visible after the final rinse If the washing result is not satisfactoryIf the washing is grey and limescale forms in the drum If there are still grey stains on the washingCarry Out an Emergency Emptying Operation Gency unlocking and remove the plug from the mains When all the washing solution has drained offEmergency Unlocking of the Filling Door Aid of the emergency unlocking facilitySet additional rinse cycle Additional rinse cycle RINCAGE+With more water Water cooling Cancel additional rinse cycleSetting water cooling Gramme duration increase Cancel water coolingAdditional rinse cycle and water cooling Set loose spin Cancel loose spinVariomatic-loose spinning Releasing the programme security Setting programme securityProgramme security Cancelling the Child Safety Feature Child Safety FeatureSetting the Child Safety Feature Safety Instructions for Installation Setting up and connection instructionsTransporting the Unit Setting Up the UnitRemove the Transport Safeguard When transporting the unit with a sack trolleySupplied with the unit Firmly pull both hose holders off the unitSetting Up on a Vibrating floor Prepare the Installation LocationSetting Up on a Concrete Pedestal Compensate for Floor Unevenness Permissible Water Pressure Electrical ConnectionWater Connection Water Inflow Draining the water into a basin Water DrainageWater Drainage into a Siphon Measurements in mm Technical DataDimensions Delivery Heads over 1mBelgium Guarantee conditionsGuarantee conditions Customer services Page Page Index When do you incur costs even during the warranty period? ServiceAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG
Top Page Image Contents