AEG 86740 manual Starting the wash program, For a set delay time

Page 25

Instructions for use

Starting the wash program

01. Checking whether the water tap is open.

2.Starting the wash programme: Press the

START/PAUSE (START/PAUZE, MARCHE /PAUSE) button.

The wash programme is started or starts after end of the set delay time.

3	If the DOOR/LIGHT (DEUR/LICHT, PORTE/ECLAIR.) display lights up red
	when pressing the START/PAUSE (START/PAUZE, MARCHE /PAUSE) but-

ton, then the door is not properly closed. Press the door firmly closed and press the START/PAUSE (START/PAUZE, MARCHE /PAUSE) button again.

For a set delay time:

the set delay time runs out, in the multi-display the remaining time up to the start of the programme is displayed (always in full hours). During this time, you can add washing or change the delay time or abort.

• Adding washing: Press the START/PAUSE (START/PAUZE, MARCHE / PAUSE) button. The door can be opened. Then close the door and press the START/PAUSE (START/PAUZE, MARCHE /PAUSE) button again.

• Changing the delay time or aborting: Press the DELAY TIMER (START- TIJDKEUZE, DEPART DIFFERE) button until the desired time is dis- played; With a display of the programme duration (display in minutes, e. g. 120) the wash programme starts immediately.

25

Image 25

Contents ÖKO-LAVAMAT 86740 update Dear customer Contents What to do if Remedying FaultsPage Before Putting into Operation for the First Time SafetyCorrect Use General Safety Child SafetyEnvironmental Tips DisposalDispose the packing material For polyoxymethylene, e.g. plastic clipsFront View Unit DescriptionDrawer for Washing Powder and Care Agent Programme knob Control PanelSilk ZIJDE, SOIE/ P handwash Wool WOL, LAINE/ P Hand wash programPRE Wash VOORWAS, PRELAV. Pre wash/Soaking Additional programme buttonsTwo levels for other programmes Programmable functionsConsumption values and time requirements TemperatureWater Protection Aqua Control + Aqua Alarm What does Update mean?Wash Time Display Preparing a Wash Load Before the first washSorting and preparing a wash load Types of washing and care symbols Water Softener How much washing detergent and care agent?Brief instructions Carrying out a wash cycleAfter completion of the wash programme Open door, remove washingSetting the wash programme Change Spin Speed / Select Rinse Hold Soaking duration Setting the delay timer/soaking time Delay timerPutting in the washing Opening and Closing the Filling DoorAdd Washing Detergent/Care Agent When using liquid washing agent/TabsCompartment for powdered washing agent/Tabs Compartment for pre-wash agent/soaking agentStarting the wash program For a set delay timeProgramme sequence display Sequence of the programmeMulti display Changing speed of spinningRemove washing Turn programme knob to OFF UIT, Arret Wash cycle ended/Remove washingLights up, too much washing detergent was used Wash Programme tablesFashion Separate Spinning Separate Rinsing/Conditioner/Starching/ImpregnationWashing Detergent Drawer Cleaning and CareFilling Door Washing DrumBefore cleaning the drain pump Cleaning the drain pumpAfter remedying the fault, press the button Remedying FaultsWhat to do if Been removed Conditioner has not Conditioner insert Rinsed, compartment No negative effect on If the washing is grey and limescale forms in the drum If the washing result is not satisfactoryIf there are still grey stains on the washing If foam is still visible after the final rinseCarry Out an Emergency Emptying Operation Emergency Unlocking of the Filling Door When all the washing solution has drained offAid of the emergency unlocking facility Gency unlocking and remove the plug from the mainsWith more water Additional rinse cycle RINCAGE+Set additional rinse cycle Setting water cooling Cancel additional rinse cycleWater cooling Additional rinse cycle and water cooling Cancel water coolingGramme duration increase Variomatic-loose spinning Cancel loose spinSet loose spin Programme security Setting programme securityReleasing the programme security Setting the Child Safety Feature Child Safety FeatureCancelling the Child Safety Feature Safety Instructions for Installation Setting up and connection instructionsRemove the Transport Safeguard Setting Up the UnitWhen transporting the unit with a sack trolley Transporting the UnitSupplied with the unit Firmly pull both hose holders off the unitSetting Up on a Concrete Pedestal Prepare the Installation LocationSetting Up on a Vibrating floor Compensate for Floor Unevenness Water Connection Electrical ConnectionPermissible Water Pressure Water Inflow Water Drainage into a Siphon Water DrainageDraining the water into a basin Dimensions Technical DataDelivery Heads over 1m Measurements in mmBelgium Guarantee conditionsGuarantee conditions Customer services Page Page Index When do you incur costs even during the warranty period? ServiceAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG