Sharp ESV80HA Setting UP Electrical Connection / Water Inlet Connection, Electrical connection

Page 12

CHAPTER -3: SETTING UP

ELECTRICAL CONNECTION / WATER INLET CONNECTION

Electrical connection

Your washing machine is set to 220-240V and 50Hz.

Water inlet connection

Your machine may have either a single inlet (cold) or double water inlets (cold/hot) based on its specifications. White-capped hose should be connected to cold water inlet and red-capped hose to hot water inlet (applicable for machines with double water inlets).

To eliminate water leakages in points of contact, 1 or 2 washers are provided in the hose package (applicable for machines with double water inlets). Fit these washers to the ends of new water inlet hoses on the side of the tap.

Connect the white-elbow end of the water inlet hoses to the white- filtered water inlet valve on the rear side of the machine and the red-elbow end to red-filtered one (applicable for machines with double water inlets). Tighten plastic parts of the junctions using your hand.

Flow of water with pressure of 0.1-1 Mpa will allow your machine to operate more efficiently (0.1 Mpa pressure means that more than 8 litres of water will flow through a fully-opened tap per one minute).

Ensure that new water inlet hoses are not folded, broken, crushed or their dimensions are not altered.

Connect new water inlet hoses to a ¾ , threaded tap.

If your machine has double hot water inlets, the temperature of hot water inlet should not exceed 70°C.

10

Image 12

Contents Washing Machine USER’S Manual Page Page Contents Technical Specifications Technical Specifications Before Using Your Washing Machine Safety Warnings Recommendations Setting UP Removing Transport Safety Screws Setting UP Removing Transport Safety Screws Setting UP Adjusting Adjustable Stays Setting UP Electrical Connection / Water Inlet Connection Electrical connectionWater inlet connection Water discharge connection Preliminary Preparation for Washing Laundry Type Preliminary Preparation for Washing Control Panel Control Panel Detergent Drawer Control Panel Programme Knob Control Panel Electronic Display Operating Your Machine First washing operationSelecting programme Auxiliary functionsHalf-load detection system Twinjet systemOperating Your Machine Program Table CottonOperating Your Machine Auxiliary Functions Spin speed selection and auxiliary function of soakingOperating Your Machine Auxiliary Functions Washing water temperature selection Auxiliary function prewash Auxiliary function for delay timer Anti-Allergic auxiliary function Operating Your Machine Starting the Programme Start/Pause buttonOperating Your Machine ADDING/REMOVING Laundry Laundry adding to / removing from the machineOperating Your Machine Child Lock Child lockOperating Your Machine Cancelling Programme Cancelling programmeOperating Your Machine Finishing Programme Finishing programmePage Page Maintenance and Cleaning of Your Machine Water Inlet FiltersMaintenance and Cleaning of Your Machine / Pump Filter As water in the pump may be hot, wait until it cools down Maintenance and Cleaning of Your Machine / Detergent Drawer Siphon plug BodyDrum Practical Information Practical Information Troubleshooting Fault Possible Cause Removing MethodsTroubleshooting Press on Start/Pause Fault Possible Cause Removing Methods Unbalanced load Automatic Fault Warnings and What to be Done FaultTrouble Code Possible What to do Fault Saving Energy and Water Disposal of Your OLD Machine