Installation
CKeep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.
CNever move the product without the transportation safety bolts properly fixed in place!
3.4 Connecting water supply
CThe water supply pressure required to run the product is between 1 to 10 bars (0.1
– 1 MPa). It is necessary to have 10 – 80 liters of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a pressure reducing valve if water pressure is higher.
CIf you are going to use the double water- inlet product as a single (cold)
A warning: Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will get damaged or the product will switch to protection mode and will not operate.
A warning: Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
1.Connect the special hoses supplied with the product to the water inlets on the product. Red hose (left) (max. 90 ºC) is for hot water inlet, blue hose (right) (max. 25 ºC) is for cold water inlet.
A warning: Ensure that the cold and hot water connections are made correctly when installing the product. Otherwise, your laundry will come out hot at the end of the washing process and wear out.
2.Tighten all hose nuts by hand. Never use a tool when tightening the nuts.
3.Open the taps completely after making the hose connection to check for water leaks at the connection points. If any leaks occur, turn off the tap and remove the nut. Retighten the nut carefully after checking the seal. To prevent water leakages and damages caused by them, keep the taps closed when the machine is not in use.
3.5 Connecting to the drain
•The end of the drain hose must be directly connected to the wastewater drain or to the washbasin.
•Drain hose shall be attached to a wall drain, stand pipe or sink siphon connected to the foul water drain, do not connect to surface water drains.
12 / EN | Washing Machine /User’s Manual |