John Lewis JLTDC12 instruction manual Starting the programme, Changing programme

Page 15

Starting the programme

Press the Start/Pause button. The programme starts.

The programme progress is shown by elapsing Dry time on LCD.

Putting in extra items or taking items out before end of programme

1. Open loading door.

Warning! Laundry and drum can

become hot. Risk of burns!

2.Load or remove laundry items.

3.Close loading securely. Lock must audibly lock.

4.Press the Start/Pause button to continue the drying cycle.

Changing programme

To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to Off and then reset the programme.

The programme can no longer be changed directly once the programme has started. If however there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the Alarm button) is pressed, Err appears in the multidisplay.

The drying programme is not however affected by this (laundry protection).

Drying cycle complete / removing laundry

Once the drying cycle is complete, the display shows the anti-crease icon and flashing "0" as well as warning lamps: Filter and Full tank . If the Alarm button has been pressed, an acoustic signal sounds intermittently for about one minute.

15

Image 15

Contents Condenser dryer with heat pump General safety Important safety informationInstallation UseCause an explosion. Only tumble dry items washed with water Spin the laundry well before drying Child safetyEnvironmental tips Environmental informationPage Contents Machine settings Description of the appliance Time button Display Dry time Programme selector and Off switchControl panel Before first useProgrammes Programme chartSorting and preparing laundry Sorting laundryPreparing laundry Selecting the programme Switching machine onDaily use Door opening and laundry loadingAnti-crease AlarmBe removed at any time during the anti- crease phase IntensiveSetting child lock Delay startStarting the programme Changing programmeDrying cycle complete / removing laundry Maintenance and cleaning Cleaning fluff filterOpen door Locks into the interlock Filter into the brackets on the loadingDoor until they snap into place Re-insert fine filterCleaning the door seal Water reservoir has a volume of approx litresEmptying the water reservoir Cleaning heat exchanger filters When doing this, please use rubber gloves Cleaning the drumWhat to do if Clean operating screen and housingMachine settings Alarm permanent on/offReplacing the drum light Press the Start/Pause button until you set desired level Adjusting the level of conductivityConsumption values Technical specificationsInstallation Transporting the applianceAppliance positioning Electrical connection Removing transport safety packagingGreen & Yellow Brown Blue Cord Clamp Green and Yellow Earth Blue Neutral Brown LiveRepairs after sales service Door reversalMod Spare parts Page Page 136912010-00-052010