Drying cycle to short
Drying cycle to long 5)
Small laundry volume./Too dry laundry for selected programme.
Fluff filters clogged.
To high loading volume.
Laundry insufficiently spun.
Particularly high room temperature - no machine fault.
Select time programme or higher drying level (e.g. Extra dry ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
1)In case of error message on the LCD (e.g. E51 ): Switch the dryer off and on. Set programme. Press the Start/ Pause button. Does not work? - inform local service and quote the error code.
2)follow program recommendation - see Programme chart chapter
3)see Maintenance and cleaning chapter
4)see Machine settings chapter
5)Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Replacing the drum light
Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local Service Force Centre.
Important! When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.
Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!
Warning! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.
1.Unscrew the cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)
2.Replace the defective bulb.
3.Screw cover back down.
Check the correct positioning of
Warning! For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.
Machine settings
Alarm permanent on/off
The alarm is by default always off. To set permanent alarm on (off):
1.Turn the programme selector to any programme.
22