John Lewis JLTDC12 instruction manual Green and Yellow Earth Blue Neutral Brown Live

Page 27

Warning! THIS APPLIANCE MUST BE EARTHED. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Force agent (see chapter: Repairs - after sales service).

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. (See picture on page 6).

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved BS 1363/A fuse must be used. Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow - Earth

Blue - Neutral

Brown - Live

GREEN & YELLOW

BROWN

BLUE

CORD CLAMP

If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug.

Proceed as follows:

1.Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter "E" or the earth symbol or coloured green and yellow.

2.Connect the Blue (neutral) wire to the terminal in the plug which is marked with the letter "N" or coloured black.

3.Connect the Brown (live) wire to the terminal in the plug which is marked with the letter "L" or coloured red.

4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.

Warning! The plug must still be accessible after the appliance has been installed.

Warning! The appliance should not be connected to the electrical supply by means of an extension cable.

27

Image 27
Contents Condenser dryer with heat pump General safety Important safety informationInstallation UseCause an explosion. Only tumble dry items washed with water Spin the laundry well before drying Child safetyEnvironmental tips Environmental informationPage Contents Machine settings Description of the appliance Time button Display Dry time Programme selector and Off switchControl panel Before first useProgrammes Programme chartSorting and preparing laundry Sorting laundryPreparing laundry Selecting the programme Switching machine onDaily use Door opening and laundry loadingAnti-crease AlarmBe removed at any time during the anti- crease phase IntensiveSetting child lock Delay startStarting the programme Changing programmeDrying cycle complete / removing laundry Maintenance and cleaning Cleaning fluff filterOpen door Locks into the interlock Filter into the brackets on the loadingDoor until they snap into place Re-insert fine filterCleaning the door seal Water reservoir has a volume of approx litresEmptying the water reservoir Cleaning heat exchanger filters When doing this, please use rubber gloves Cleaning the drumWhat to do if Clean operating screen and housingMachine settings Alarm permanent on/offReplacing the drum light Press the Start/Pause button until you set desired level Adjusting the level of conductivityConsumption values Technical specificationsInstallation Transporting the applianceAppliance positioning Electrical connection Removing transport safety packagingGreen & Yellow Brown Blue Cord Clamp Green and Yellow Earth Blue Neutral Brown LiveRepairs after sales service Door reversalMod Spare parts Page Page 136912010-00-052010