John Lewis JLTDC12 Installation, Transporting the appliance, Appliance positioning

Page 25

Installation

Transporting the appliance

Important! Only tip the appliance on its left side to transport (see illustration), if it cannot be transported in an upright position.

•Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine.

•To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.

•Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is.

•The feet must never be removed. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance.

Appliance positioning

•It is recommended that, for your convenience, the machine is positioned close to your washing machine.

•The tumble dryer must be installed in a clean place, where dirt does not build up.

25

Image 25

Contents Condenser dryer with heat pump General safety Important safety informationUse InstallationCause an explosion. Only tumble dry items washed with water Environmental tips Child safetyEnvironmental information Spin the laundry well before dryingPage Contents Machine settings Description of the appliance Control panel Programme selector and Off switchBefore first use Time button Display Dry timeProgrammes Programme chartSorting laundry Sorting and preparing laundryPreparing laundry Daily use Switching machine onDoor opening and laundry loading Selecting the programmeBe removed at any time during the anti- crease phase AlarmIntensive Anti-creaseSetting child lock Delay startChanging programme Starting the programmeDrying cycle complete / removing laundry Cleaning fluff filter Maintenance and cleaningOpen door Door until they snap into place Filter into the brackets on the loadingRe-insert fine filter Locks into the interlockWater reservoir has a volume of approx litres Cleaning the door sealEmptying the water reservoir Cleaning heat exchanger filters When doing this, please use rubber gloves Cleaning the drumWhat to do if Clean operating screen and housingAlarm permanent on/off Machine settingsReplacing the drum light Press the Start/Pause button until you set desired level Adjusting the level of conductivityConsumption values Technical specificationsTransporting the appliance InstallationAppliance positioning Electrical connection Removing transport safety packagingGreen & Yellow Brown Blue Cord Clamp Green and Yellow Earth Blue Neutral Brown LiveDoor reversal Repairs after sales serviceMod Spare parts Page Page 136912010-00-052010