Technics SC-DV170 »A Setting the time, »B Turning Demo off, » Saving power in the standby C mode

1

1 2 2 3

Before use

CLOCK/TIMER

—DEMO

A

1 H/I

2 1 CLOCK/TIMER —DEMO

2

SET

3 1 ? TUNING @

2

SET

B

CLOCK/TIMER

—DEMO

C

1 MODE

2

MODE

RQT5471

»A Setting the time

This is a 24-hour clock.

The example shows how to set the clock for 16:25 (4:25 p.m.).

1 Press [ê/I] to turn the unit on.

2 1 Press [CLOCK/TIMER, –DEMO] to display “CLOCK”.

Each time you press the button:

CLOCK>FPLAY>FREC>Original display

^------------------------------------------------------------------- }

2Within 7 seconds

Press [SET].

3 1 Press [TUNING (X or W)] to set the time.

The time display can be changed in one minute units by tapping the buttons, and quickly by holding down the but- tons.

2Press [SET].

The time is set and the original display is restored.

Displaying the clock

Press [CLOCK/TIMER, –DEMO].

The clock is shown for about 5 seconds.

»B Turning DEMO off

A demonstration of the display is shown if you have not set the clock. Turn DEMO off to get the most from ECO mode (see below).

While the unit is on:

Press and hold [CLOCK/TIMER, –DEMO] until “NO DEMO” is displayed.

Each time you press and hold the button:

NO DEMO (off)bDEMO (on)

»Saving power in the standby C mode

Set the unit to reduce energy consumption in the standby mode (11 W>0.5 W for the United Kingdom, Continental Europe, Russia, Australia and N.Z. or 11 W>1.0 W for others).

While the unit is on:

1Press [MODE].

The current mode is displayed.

2Within 5 seconds

Press [MODE] to display “ECO”.

Each time you press the button:

NORMAL (off)bECO (on)

ECO: The clock is not displayed in the standby mode. The “ê” and the “FPLAY/FREC” indicators still light.

Note

The mode can be switched to ECO when the unit is in standby but it cannot be switched back to NORMAL.