Technics SC-DV170 manual Press Counter Display, Recording operations, Reset Display

Recording operations

A	COUNTER
	RESET DISPLAY

DECK 1/2

COUNTER

DISPLAY

COUNTER

RESET

B

a Side A

bTab for side “B” c Tab for side “A” d To re-record

e Normal tape	f High-position tape
A	A
	g Discrimination hole

C

1

3 5 2

64

Before recording (Deck 2 only)

Selection of tapes for recording

The unit automatically identifies the type of tape.

Normal position/TYPE I	4
High position/TYPE II	4
Metal position/TYPE IV	4

»	To display the tape counter while recording
A

Press [COUNTER DISPLAY].

The counter is displayed for about 5 seconds.

To reset the tape counter

Press [COUNTER RESET].

³To display or reset the tape counter for deck 1, first press [DECK 1/2].

»	Erasure prevention
B

The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown, being careful not to cover the high position discrimination hole.

Volume, sound quality and surround effects

These have no effect on recording. Sound quality and surround effects are automatically set to flat when recording.

»	Erasing recordings
C

1Press [INPUT SELECTOR] to select “TAPE”.

2 Insert the recorded tape into deck 2.

3 Press [DOLBY NR] so the “ëNR” indicator goes out. 4 Select the reverse mode.

5 Press [´ REC PAUSE].

6 Press ["] or [!].

Your attention is drawn to the fact that recording pre-recorded tapes or discs or other published or broadcast material may infringe copyright laws.

RQT5471