Technics SC-DV170 manual Changing sound field and quality, Turn Multi JOG to select a setting

Changing sound field and quality

MULTI JOG

		2	1, 3
A		a (On the tuner/amplifier)
	MULTI JOG
		b (On the sound processor)
		FLAT	HALL
		HEAVY	AI-EQ
		CLEAR	M.EQ
B
1	MULTI JOG	b (On the sound processor)
		FLAT	HALL
		HEAVY	AI-EQ
		CLEAR	M.EQ
2	3D AI EQ/	a (On the tuner/amplifier)
	M.EQ BAND

3 2

MULTI JOG

11

2b (On the sound processor)

MID

1
	FLAT			HALL
	HEAVY			AI-EQ
	CLEAR			M.EQ
		LOW	HIGH
2
	FLAT			HALL
	HEAVY			AI-EQ
	CLEAR			M.EQ
c
	FLAT			HALL
	HEAVY			AI-EQ
	CLEAR			M.EQ

C

FLAT				HALL
HEAVY	d	e	f	AI-EQ
CLEAR				M.EQ

Changing sound field and quality

Changes to sound field and quality have no effect on recordings.

[A]

Turn [MULTI JOG] to select a setting.

Each time you turn [MULTI JOG]:

HEAVY: Adds power to rock.

CLEAR:	Clarifies higher sounds.
HALL:	Expands sound.
AI-EQ:	Adjust sound with the acoustic image equalizer
	(á page 29).
M.EQ:	Create your own effects (á see below).
FLAT:	Canceled (no effect is added).

On the remote control

Press [SHIFT] i [EQ].

Note

Turn off the effect if sound quality is reduced when using HALL or 3D AI EQ with a source.

»B Using the manual equalizer

Create your own sound quality effects.

1 Turn [MULTI JOG] to select “M.EQ”.

2 Press [3D AI EQ/M.EQ BAND] to se- lect the band.

Each time you press the button:

LOW>MID>HIGH ^------------------------}

3 Use [", !, #, $] to make the desired curve.

1Select the frequency you want to use as the peak with [",

!].

2Adjust the level of the peak with [#, $].

³Adjacent frequencies are adjusted at the same time to maintain a smooth curve.

³When you have adjusted the curve, you can move the peak of the curve by pressing [", !] (c).

Repeat steps 2 and 3 to adjust the three bands.

The original display is restored on the display panel in about 5 seconds.

To cancel

Turn [MULTI JOG] to select “FLAT”.

Note

³The changes you make are stored and automatically recalled the next time you select “M.EQ”.

³After making a curve in one band, any adjustments in another band make a curve that is a combination of the two.

[C]To flatten the curves in all three bands

Set the frequencies d in LOW, e in MID, and f in HIGH to flat.

RQT5471