Technics SC-DV170 Radio preset tuning, Automatic presetting, Hold down SET, Manual presetting

SET

TUNING MODE 2,4 3

A SET

MHz

B

SET

2

3 ? TUNING @

4 SET

C

		SUBTITLE	SETUP
H	SLEEP	TOP MENU	DISPLAY
			DISC
1	2	3
			j/-/--	2
4	5	6
7	8	9	0
MENU			RETURN
EQ	ENTER

3D AI EQ/
M.EQ BAND			AV EFFECT
MARKER			ANGLE
UPRO LOGIC	TEST	DIGITAL
	CH SELECT	S.WOOFER	SUPER SRND	1
VCR(EXT)/	TAPE/	DVD	TUNER/
VDP(AUX)	DECK 1/2		BAND
CANCEL	Ú/g	È	Û
PLAY MODE
MIX 2CH
AUDIO		SLOW/SEARCH
SHIFT	MUTING	SKIP
				3
¶	VOLUME		µ

1 TUNER/ BAND

2	1	2	3		a Preset channel
				j/-/--
	4	5	6
	7	8	9	0
3	¶		VOLUME		µ

The radio: preset tuning

You can choose either automatic presetting, which presets all the stations the tuner/amplifier can receive, or manual presetting, which allows you to select the stations to preset and the order they are to be preset in.

There are 39 channels available for presetting.

A	Automatic presetting
»
Do the following once each for FM and AM.
Preparation: Tune to the frequency where presetting is to begin
	(á page 24).
Hold down [SET].
Release the button when “AUTO MEMORY” appears.
		operations
The tuner presets all the stations it can receive into the channels in
ascending order. FM stations are preset into channels 1 to 39, and
AM stations are preset into channels 21 to 39.
“SET OK” is shown when presetting is complete and the last station
that was preset is played.
“ERROR” is displayed if the tuner doesn’t receive any stations. Try		Basic
presetting manually if this happens (see below).
Note
AM stations replace any FM channels that were preset in channels
21 to 39.
B	Manual presetting
»
Preset the stations one at a time.
1 Tune to the required station.
2	Press [SET].
3 Press [TUNING (X or W)] to select a
	channel.
4	Press [SET].

The station occupying a channel is erased if another station is preset

in that channel.

»C Selecting channels

On the remote control

1 Press [TUNER/BAND].

2 Press the numbered buttons to select the channel.

For channels 1 to 9 press the corresponding number. For channels 10 or over press [L], then the two digits. e.g. To select channel 21: [L]>[2]>[1]

3 Adjust the volume.

On the main unit

1Select “PRESET” with [TUNING MODE].

2Press [TUNING (X or W)] to select the channel.

25

RQT5471